Installation Support • No Nonsense™ Warranty •(800) 875-5285 • www.WarmlyYours.com
TOOLS REQUIRED
PARTS LIST
INSTALLATION INSTRUCTIONS
- Review instructions carefully before installation
- Installation should be completed by a qualified person
- Please dispose of packaging in a responsible manner
2x4
Stud
C
D
B
1-2
4-5
3
6
A B C D E
F G H I J
K L M N O
M8x65
M6*10
ST4.2*40
4x
4x
1x 1x 2x 1x 1x
4x
4x 4x 4x 4x
4x 4x 4x
BD
H
F
D
C
550mm (21.7”)
578mm (22.8”)
AGE
Step 1:
Before you
start assembly
make sure
components
listed below are
in the package
Step 2:
insert plastic
bush (G) in
tube (E)
Step 6:
Remove bushings
(D) from tube and
using the screw (C)
and the plug (B)
provided, fix the
bushing to the wall.
Depending on the
type of wall, other
methods can also be
used to fix the
bushings to the wall.
Step 4:
Insert metal
bushing (D) in
each tube and
place frame
against wall. Make
sure the frame is
level.
Step 5:
Using a pencil,
nake the position
of the bushes on
the wall.
Step 3:
Using screw
(A) attach the
tube to the
nut on the
back of the
frame with
allen key (O)
AGO
E
MADRID INSTALLATION MANUAL
WALL MOUNTED / FLOOR MOUNT
Installation Support • No Nonsense™ Warranty •(800) 875-5285 • www.WarmlyYours.com
7-8 Floor Mount
MADRID INSTALLATION MANUAL
WALL MOUNTED / FLOOR MOUNT
Voltage 110VAC Rated Frequency: 60Hz
Power Rating: 120W
Step 7:
Mount the frame
onto the bushings
(D) that are fixed to
the wall and make
sure the tubes are
flush against the
bushing.
Step 8:
Tighten all the sey
screws (F) with the
allen key (N) DO NOT
OVER TIGHTEN.
Make sure frame is
firmly fixed to wall.
H
F
D
H
L
J
L
M
M
K
K
I
I
J
After installation is complete, connect the electric power and turn on the Power Switch. The
unit will begin to heat. If the unit will not be used for an extended time, simply turn the unit off
using the power switch.
1. Do not hook the unit up to a circuit until completely reading
these instructions.
2. This product is intended only for domestic use. Do not put
the unit into water. Do not use in a sauna, shower cubicle or
steam room. This product is for indoor use only.
3. If the heating wire inside the unit fails or becomes damaged,
turn the unit OFF and contact WarmlyYours. Do NOT attempt to
repair
or remove the power switch or heating wire.
4. If you encounter any difficulties while installing your Towel
Warmer, installation support is available by phone, 24/7 at
(800) 875-5285.
5. If a return is necessary, please use original packaging if
possible.
/
