2. Baxton Studio
  3. BBT5280-Greyish Beige/Walnut-5 PC Dining Set

Baxton Studio BBT5280-Greyish Beige/Walnut-5 PC Dining Set, BBT5280-Dark Grey/Walnut-5PC Dining Set, BBT5280-Gravel/Walnut-5PC Dining Set Assembly Instructions

  • Hello! I've reviewed the assembly instructions for the BBT5280 Dining Chair. This document includes step-by-step guidance, parts lists, hardware requirements, and safety precautions. I'm ready to help you with any questions you might have about the assembly process.
  • Should I tighten all nuts and bolts completely during the initial assembly?
    What should I do to avoid damaging the chair during assembly?
    Where should i keep hardware during assembly process?
HARDWARE LIST
ITEM DESCRIPTION QTY
1 JCBC Bolt M6 x 50mm 4 PCS
2 WOOD SCREW M4 x 38mm 4 PCS
3 WOOD DOWEL M10 x 40mm 8 PCS
4 M4 ALLEN KEY (BALL SHAPE) 1 PC
Read this instruction carefully. See hardware and furniture part list for guidance.
Be sure all parts are complete, before you assemble. Place all wooden furniture
parts on a clean and flat soft surface to prevent from being scratched.
Follow the figure to start assembling.
CAUTIONS : 1. Do not FULLY - TIGHTEN the nut or nut bolt until all nut or bolt is ready assembed.
2. Do not OVER - TIGHTEN the nut or bolt to avoid causing damages to the thread.
3. Keep all hardware parts out of reach of children.
NOTE : THE LIST AND QUANTITY SHOWN ARE FOR 1 UNIT ASSEMBLY.
Tool needed : Screwdriver & Hammer (not provided).
ASSEMBLY INSTRUCTIONS
MODEL : BBT5280 DINING CHAIR PAGE 1 OF 2
STEP A STEP B
x2
STEP 1 STEP 2
PART LIST
ITEM DESCRIPTION QTY
A CHAIR 1 PC
B LEG (L) 1 PC
C LEG (R) 1 PC
D SUPPORT RAIL (LONG) 1 PC
E SUPPORT RAIL (SHORT) 1 PC
E
D
C
E
D
1
4
3
LONG
SHORT
R
ASSEMBLY INSTRUCTIONS PAGE 2 OF 2
STEP A
STEP B x2
x4
STEP 3 STEP 4
STEP 5
B
2
A
2
4
1
Note : Follow the line drawing to assemble the chair leg.
L
R
L
PART LIST
ITEM DESCRIPTION QTY
A TABLE TOP 1 PC
B LEGS 4 PCS
ASSEMBLY INSTRUCTIONS PART LIST
ITEM DESCRIPTION QTY
1 JCBC BOLT M6 x 60mm 8 PCS
2 M6 FLAT WASHER 8 PCS
3 M6 SPRING WASHER 8 PCS
4 M4 ALLEN KEY 1 PC
STEP 1
Read this instruction carefully. See hardware and furniture part list for guidance.
Be sure all parts are complete, before you assemble. Place all wooden furniture
parts on a clean and flat soft surface to prevent from being scratched.
Follow the figure to start assembling.
CAUTIONS : 1. Do not FULLY - TIGHTEN the nut or nut bolt until all nut or bolt is ready assembed.
2. Do not OVER - TIGHTEN the nut or bolt to avoid causing damages to the thread.
3. Keep all hardware parts out of reach of children.
NOTE : THE LIST AND QUANTITY SHOWN ARE FOR 1 UNIT ASSEMBLY.
STEP 2
A
B
2
3
1
4
/