Page is loading ...
DIGIT-
EYEZ
LED EYE LIGHTS
Instruction Manual
Read through this entire instruction manual BEFORE using
Digit-Eyez. We’re dedicated to bringing you well-designed
products that make living fun and easy. We stand behind
all our products and warrant this to be free from defects in
workmanship and materials.
For service claims or questions please consult our website
ProtocolDesign.com.
WARNINGS:
- Use with adult supervision.
- Use only eyelash glue with this product.
- Do not expose to water.
TM
COVER
BACK
PARTS: SET UP:
1. Press and hold the power button for 2 seconds to turn
lights on.
2. Press power button to cycle through light modes.
3. Press power button for 2 seconds to turn lights off.
1. Pull the plastic tab off the battery.
2. Connect the eye lights to the connection ports.
3. Attach the circuit board to the back of the head using
the included clip.
4. Using your preferred eyelash glue, apply the eye strips flat
side down to eyelids. (FIG. 1)
Connection Port
Power
Button
Eye Strip
Eye Strip
Battery
Circuit Board
USE:
FIG. 1
/