NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
GENERAL INFORMATION
The Trim kit is intended to be used as a decorative addition to the
fireplace models listed on this instruction sheet. Please read this
instruction sheet in its entirety before applying this kit to the fireplace.
NOTE: Two Trim Kits may be required for See-Thru applications,
depending on installation.
TURN OFF THE FIREPLACE AND ALLOW IT TO COMPLETELY COOL
BEFORE PROCEEDING.
TURN OFF GAS AND POWER TO THE APPLIANCE AND USE LOCK-
OUTS TO PREVENT ACCIDENTAL/UNSAFE OPERATION.
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND
OPERATION MANUAL PROVIDED WITH THE FIREPLACE APPLY TO
THESE INSTRUCTIONS.
WARNING
Only use materials listed here. Only authorized mate-
rials have been tested for use within the fireplace and
its environment. Do not attempt to use any different
materials in the fireplace. Doing so may be dangerous
and will void the warranty.
IMPORTANT NOTICE
TRIM KIT SHOULD BE INSTALLED AFTER ALL FINISHING
MATERIALS HAVE BEEN APPLIED TO THE FIREPLACE.
TRIM KITS
INSTALLATION INSTRUCTIONS FOR LINEAR TRIM KITS
[FOR USE WITH ASTRIA ALLUME & ALLUME DLX SERIES, AND SUPERIOR DRL4000 & DRL6000 SERIES FIREPLACES]
HEARTH PRODUCTS
KITS AND ACCESSORIES
900931-00 REV. A 11/2020
INSTALLER: Leave this manual with the appliance
CONSUMER: Retain this manual for future reference
LINEAR TRIM KITS
Fireplace Cat. No. Model Description
60” F3778 TRMK-BLK-LIN60 Kit, Linear 60 Trim, Black
72” F4406 TRMK-BLK-LIN72 Kit, Linear 72 Trim, Black
84” F4407 TRMK-BLK-LIN84 Kit, Linear 84 Trim, Black
KIT CONTENTS
1 ea. Trim Assembly
1 ea. Instruction Sheet
TOOLS NEEDED (NOT SUPPLIED)
One Flat Head Screwdriver
One Pair Of Pliers
Figure 1 - Kit Contents Overview
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Figure 2 - Installing Decorative Trim
Side
Filler
Tab
Trim
Flanges
INSTALLATION
Installing Trim Kit
With the fireplace in place and all finishing materials applied to the fireplace, follow these steps to install the trim kit.
1. With a flat head screwdriver, open the tabs enough to grab them with a conventional pair of pliers and bend them at 90° on the left
and right side tile stops, top/bottom (Figure 2).
2. Grab the decorative trim and engage the trim flanges into the tile stop tabs (Figure 2).
NOTE: The trim flanges have gear type cutouts for adjustment purposes.
Innovative Hearth Products (IHP) reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to
discontinue colors, styles and products. Consult your local distributor for fireplace code information.
Printed in U.S.A. © 2018 Innovative Hearth Products
P/N 900931-00 REV. A 11/2020
IHP
1769 East Lawrence Street • Russellville, AL 35654
-
1
-
2
Astria Fireplaces DRL6000 Instruction Sheet
- Type
- Instruction Sheet
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Astria Fireplaces MONTEBELLO ST Operating instructions
-
-
-
-
-
-
-
-
-
Other documents
-
Superior Fireplaces DRL4000 Operating instructions
-
-
-
-
-
-
-
-
-