FM MODULATOR
If your car stereo system does not have an auxiliary input for the
audio from your DVD or VCP (VCR), you can play the audio through
the FM tuner of your existing car stereo system by using this FM
modulator and tuning to a specific radio frequency.
1. ANTENNA
a. ANTENNA INPUT:
Disconnect the antenna cable from your car stereo (receiver).
Plug the antenna cable into the large black connector on the
FM modulator. When the FM modulator is turned on the tuner
will not receive radio stations.
b. RF OUTPUT:
Connect the output cable of the FM modulator to the antenna
input jack on your car stereo (receiver). When the FM
modulator is turned off the tuner will receive radio stations as
normal.
2. POWER SUPPLY
c. GND (–)
d. POWER SUPPLY 12V (+)
Connect the power supply wire (2) to the ACC power output
terminal.
ATTENTION:
The red wire (d) is connected to the positive (+) terminal, and
the black wire (c) to the negative (–) terminal.
4