2. Industrial & lab equipment
  3. Electrical equipment & supplies
  4. Circuit protection
  5. Surge protectors
  6. Cyber Power
  7. HT705GR

Cyber Power HT705GR Quick start guide

  • I have reviewed the provided user guide for the CyberPower Surge Protector Tier 2 APS HT705GR. This document details the setup procedures, including turning the power on and off and connecting various electronic devices to the surge protector. Additionally, the document discusses the energy-saving timer and the infrared sensor usage that helps to manage power consumption. I'm ready to answer any questions you may have about this device and its operation.
  • How do I turn the power off?
    How do I connect the IR sensor?
    How do I change the energy saving timer?
HT705GR Tier 2 APS
QUICK START GUIDE
SETUP:
1. Turn power switch to OFF.2. Plug surge protector into wall.
5. Place glossy side of IR sensor in sightline of remotes. 6. Turn power switch to ON.
4. Connect infra-red (IR) sensor to surge
protector with small input jack.
3. Plug powered-down electronic devices in to appropriate outlets.
PEEL
Audio Equipment
DVD Player
TV
Gaming Console
without Hard Drive
Gaming Console
with Hard Drive Cable Box DVR
/
OPERATION:
1. Power TV ON.2. Power ON DVD player, game console, speakers, etc.
3. Energy saving timer’s default setting is 1 hour. The IR sensor’s blue LED light will blink for 4.5
minutes after one hour of last click of remote. Click any button on a TV remote or the volume
button on a cable provider’s remote to restart energy saving timer to zero. Blue LED light will
stop blinking for another hour.
4. Power OFF when done watching.
One Hour:
1. Hold the IR sensor button down
for 7 seconds.
2. LED light will flash 3 times, release.
3. Press IR sensor 1 time.
4. LED light will flash 1 time,
and timer will be 1 hour.
NOTE: IR sensor blinks for 1 minute after TV powers o. Power strip will turn o
energy saving outlets.
Two Hours:
1. Hold the IR sensor button down
for 7 seconds.
2. LED light will flash 3 times, release.
3. Press IR sensor 2 times, pausing
in between.
4. LED light will flash 2 times,
and timer will be 2 hours.
Need Additional Help? Feel free to contact our
Tech Support department with installation,
troubleshooting, or general product questions.
CyberPower Technical Support
1-877-297-6937 | tech@cpsww.com
cyberpowersystems.com
4241 12th Avenue E, Suite 400,
Shakopee, MN 55379, USA
Monday–Friday, 7am–6pm (CST)
This document is believed to be accurate, but CyberPower reserves
the right to change or correct the contents and does not assume
any responsibility for omissions or errors. Entire contents copyright
© 2023 Cyber Power Systems (USA), Inc. All rights reserved. Repro-
duction in whole or in part without permission is prohibited.
CHANGING ENERGY SAVING TIMER
Audio Equipment
DVR
Cable Box
Gaming Console
DVD Player
K01-0000700-01
/