2. Contixo
  3. SC1

Contixo SC1 Owner's manual

  • Hello! I've reviewed the user manual for the Speed Crawler SC1. This manual will guide you through various aspects of the device, including powering it on, using the wrist remote, installing batteries, filling the smoke chamber, understanding battery warnings, and charging techniques. There are also detailed instructions about its different control modes and how to use additional features like the spray and music player options. I am ready to answer any questions you may have.
  • How do I turn on the Speed Crawler SC1?
    How do I switch to Mode 2?
    How do I activate the spray function?
    How to fill the smoke chamber?
*product colors may vary
PLEASE READ THIS MANUAL BEFORE USING.
PLEASE RETAIN THIS INFORMATION FOR FUTURE REFERENCE
Speed Crawler SC1
User Manual
Press here
Hold down the Power button
for 2 seconds to turn on the
SC1 Speed Crawler
Powering it On
How to turn on the SC1
Boot
Long Press Power
Button to turn on.
Put it on
Put your thumb
through the rubber
loop and strap it
around your palm.
Attach the mode-
switch button around
your index finger so
that your thumb can
press it easily.
Mode 1: Default mode when device is turned
Mode 2: Alternate Controls
3 LED’s blinking 3 times fast
indicate the remote is booted
Remote is looking for
SC1
Remote is connected, and in
Mode 1
Mode 3: Music Player
Move SC1 forward,
back, left, and right
Move SC1
forward/back
Car leans and
lurches left/right
Toggle between
Stealth Formation
and Truck Formation
in Mode 1 and Mode 2
• Click once to switch
to Mode 2
• Double click to switch
to Mode 3
Rotate SC1
left/right
SC1 leaning
left and right
Tilt Forward: Next song
Tilt Back: Previous song
Tilt Forward/Back and
Hold 3 seconds: Spray On/Off
Tilt Left: Volume down
Tilt Right: Volume up
SC1 Wrist Remote
How to use
SC1 Remote Control
How to use
Left Forward
Move
Forward/Back
Move
Left/Right
Speaker
Programming
Mode Short Press Music Mode
Long Press For 3 seconds Spray
Toggle
Stealth/Truck
Mode
Right Forward
Automatic
Demo
Vol+Vol-
Forward &
Left
Forward &
Right
Slide Left Slide Right Backward &
Left
Backward &
Left
Spin Left Spin Right
Before switching to a new remote control, you need to turn off the
previously connected remote control.
Battery Installation
SC1 Battery Installation
1.
2.
3.
*When removing the battery to charge, take care to unclasp the connector before pulling it off.
Remote Battery Installation
1.
2.
3.
Use a small phillips head screwdriver to remove the battery cover.
Replace the battery cover and screw back into place.
Fill Up The Smoke Chamber
The battery of the remote control watch does not need to be installed. Connect the charging cable
to the charging port for charging.
Open the stopper at the front of the car and pour water with the bottle included in the package.
Battery Warnings
Battery Charging
Recycling
Charging Time
1.
2.
3.
immediately.
Recommend using a 5V 1A charger (Not included) for charging.
1.
2.
3.
5.
6.
7.
8.
light turns on charging
180 20
cable. cable
CONTACT INFORMATION
E-Mail: support@con�xo.com
Website: www.con�xo.com
©2021 Con�xo Inc. All rights reserved. Con�xo®, the Con�xo logo and
associated characters, trademarks and design elements are owned and
licensed by Con�xo Company.
/