All Cutmaster True

Thermal Dynamics All Cutmaster True, All Cutmaster True (Except CM 39 and CM 10) Troubleshooting instruction

  • Hello! I am an AI chatbot trained to assist you with the Thermal Dynamics All Cutmaster True Troubleshooting instruction. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
TECHNICAL
BULLETIN
Date: 02/9/2010
Product: All Cutmaster TRUE (except CM 39 and CM 10)
Subject: Standoffs soldering joints
Summary: Inspection and Rework if applicable
THERMAL DYNAMICS TECHNICAL SUPPORT
Phone: 1-800-752-7622
Fax: 1-603-298-7402
tdc-tech@thermadyne.com
www.thermadyne.com
Form 0020
82 Benning Street
West Lebanon, NH 03784
1-603-298-5711
Fax: 1-800-221-4401
“Exceeding Customer Expectations Through Performance Excellence"
Valued Thermadyne Service Provider,
It has come to our attention that a small batch of Main PCBoards on the Cutmaster units may have a problem
with the soldering on the Standoffs. Even though most of the boards were caught in house we feel is important to
make you aware of this situation and perform a simple inspection when you happen to receive a Cutmaster unit
in you shop:
9 Review date code of the Main PCBoard (see the picture below).
9 If the Main PCB has the code 11/09 replace.
Note: The previous procedure only applies for boards with date code 11/09
. There is no need to replace the Main
boards with a different date code.
Please do not hesitate to contact us if you have any questions
/