Installation Guide
Sealing of holes in Prof1
PVRE and PVRET bases
© Danfoss A/S, 2014-03 11078864 • Rev CC • Mar 2014 1
11078864
11078864
Sealing kit:
The sealing kit is for more types of plastic covers used for Prof1, PVRE and PVRET.
Part A1 to C3 is for tightening holes in the plastic cover.
D1 is for types with SUB-D connector.
E1 to E4 is for types with wired connectors.
A1
B1
B2
C1
D1
C2
C3
A2
E1
E2
E3
E4
2 11078864 • Rev CC • Mar 2014 © Danfoss A/S, 2014-03
Sealing of plastic cover with holes
The amount of holes is pending the specific model of the joystick. You might not find all the holes in your joystick and therefore
maybe not all stickers are needed.
Start by mounting A1 and A2 Mount B1 and B2
Mount C1 to C3 one sides.
© Danfoss A/S, 2014-03 11078864 • Rev CC • Mar 2014 3
Joysticks with SUB-D connectors must be sealed with D1
It is important that the sealing is mounted the right way
When the sealing is in place, the plug will lock its position.
→
4 11078864 • Rev CC • Mar 2014 © Danfoss A/S, 2014-03
Joysticks with wire connectors must be sealed with E
Mount sealing E1 around the wire. E2 must be mounted to support the sealing E1
/
