Audiovox VX3010 Installation guide

Brand: Audiovox

Model: VX3010

Category: Motorcycle Accessories

Type: Installation guide

Audiovox VX3010 is a car audio system that comes with a range of capabilities to enhance your driving experience. It features a built-in DVD/CD player, allowing you to enjoy your favorite movies and music on the go. The system also supports Bluetooth connectivity, enabling you to stream music wirelessly from your smartphone or other compatible devices. Additionally, the VX3010 comes equipped with a USB port, providing a convenient way to connect and play music from external storage devices. The system also includes an AM/FM tuner, so you can stay updated with your favorite radio programs.

VX3010

Installation Guide

What’s in the Box

The following items are supplied with

the VX3010:

• VX3010HeadUnit

• TrimRing

• HardwareBag

• Power/SpeakerOutputHarness

• RemoteControl

• ExternalMicrophone

• MountingSleeve&RemovalKeys

• OwnersManual&WarrantyCard

• InstallationGuide

Tools and Supplies

The following tools and supplies are

needed to install the VX3010:

• Torx type, at-head and Philips

screwdrivers

• Wire cutters and strippers

• Tools to remove existing radio (screw

driver, socket wrench set or other

tools)

• Electrical tape

• Crimping tool

• Volt meter/test light

• Crimp connections

• 18 gauge wire for power connections

• 16 – 18 gauge speaker wire

WARNING!Neverinstallthisunitwhereoperationandviewingcouldinterferewith

safedrivingconditions.

INSTALLATION GUIDE

128-9271 VX3010 Installation Guide 01-16-14.indd 1 1/16/2014 1:29:51 PM

128-9271 VX3010 Installation Guide 01-16-14.indd 2 1/16/2014 1:29:51 PM

Optional Equipment

• Steering Wheel Control (SWC)- The VX3010 is SWC ready for vehicles equipped with the option. See wiring diagram for

installation details. For SWC programming details, please see the operation manual.

• Rear Camera- The VX3010 is Rear Camera ready for vehicles equipped with the option. See wiring diagram for installation

details.

Disconnect the Battery

• To prevent a short circuit, be sure to turn o the ignition and remove the negative (-) battery cable prior to installation.

NOTE: If the VX3010 is to be installed in a car equipped with an on-board drive or navigation computer, do not disconnect the

battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution

during installation to avoid causing a short circuit.

Replacing the Fuse

• When replacing the vehicles Radio fuse always use the proper rated replacement fuse. Using a fuse with an improper rating

could damage the unit and cause a re.

ISO-DIN Installation

The VX3010 is designed to t into a 1.0 DIN dashboard opening. The unit has threaded holes in the chassis side panels which may be

used with the original factory mounting brackets of some Toyota, Nissan, Mitsubishi, Isuzu, Hyundai and Honda vehicles to mount

the radio to the dashboard. Please consult with your local car stereo specialty shop for assistance on this type of installation.

NOTE: It is the end-users responsibility to install and operate this unit in a manner in accordance with local, state and federal laws.

The PARKING BRAKE wire MUST BE CONNECTED as directed in the manual.

Using the Cosmetic Trim Ring

A cosmetic trim ring is supplied with the head unit for installation exibility. This unit will t into most import dashes with little or

no modication to the dash board/cavity. Some US domestic vehicle dashes will accept a Single-DIN chassis, but there is usually a

small gap between the radio and dash piece after installation is complete. In this case, use the trim ring to conceal any gaps that

may be present.

1. Remove the existing factory radio from the dashboard or

center console mounting. Save all hardware and brackets as

they will be used to mount the new radio.

2. Remove the factory mounting brackets and hardware from the

existing radio and attach them to the new radio.

CAUTION! Do not exceed M5 X 6MM screw size. Longer screws

may damage components inside the chassis.

3. Place the radio in front of the dashboard opening so the wiring

can be brought through the mounting sleeve. Follow the

wiring diagram carefully and make certain all connections are

secure and insulated with wire nuts or electrical tape. After

completing the wiring connections, plug the ISO connectors

into the mating sockets on the rear of the chassis. Turn the

unit on to conrm operation (vehicle ignition switch must be

“ON”). If the unit does not operate, re-check all wiring until the

problem is corrected.

4. Mount the new radio assembly to the dashboard or center

console using the reverse procedure in step 1 above.

CAUTION! Be careful not to damage the car wiring.

NOTE: For proper operation of the CD/DVD player, the chassis must be mounted within 30° of horizontal. Make sure the unit is

mounted within this limitation.

Mounting

The rear of the unit

Trim plate

Rubber Sheath

Dash Board

128-9271 VX3010 Installation Guide 01-16-14.indd 3 1/16/2014 1:29:52 PM

Wiring Diagram

CAUTION! IMPORTANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully,

or have the installation handled by an experienced technician.

Need Help? For technical assistance, call the Jensen customer support line at 1-800-323-4815.

The VX3010 has a built-in SWC Interface compatible with most resistive type OE steering wheel controls. In most installations, only two of the three wires will be needed to

interface the OE steering wheel controls to the VX3010.

SWC A - Primary SWC Wire

SWC B - Secondary SWC Wire

SWC Ground - Chassis ground

Initial wiring of the SWC interface should include the SWC A and SWC Ground wire. If this combination of wiring does not support your vehicle functions, then try the SWC B

and SWC Ground wire combination. Do not use only SWC A and SWC B. The SWC Ground must be connected.

Some vehicles may not support all SWC functions. Professional Installation is recommended.

YELLOW

SWC Adapter Cable

PARK

VIDEO OUT

BLACK

ANT

AUTO ANTENNA

MONITOR

BACKUP

CAMERA