VX4022A
Installation Guide
WARNING! Never install this unit where operation and viewing could interfere with
safe driving conditions.
What’s in the Box
The following items are supplied
with the VX4022A:
•
VX
4022A Head Unit
•
Trim Rings
• Hardware Bag
• Power/Speaker Output Harness
• Remote Control
• External Microphone
•
Installation Guide / Warranty
Tools and Supplies
The following tools and supplies
are needed to install the
VX4022A:
at-head and Philips
screwdrivers
• Wire cutters and strippers
• Tools to remove existing radio (screw
driver, socket wrench set or other
tools)
• Electrical tape
• Crimping tool
• Volt meter/test light
• Crimp connections
• 18 gauge wire for power connections
• 16 – 18 gauge speaker wire
•
Mounting Sleeve / Side Brackets
1
Optional Equipment
•
Steering Wheel Control (SWC) Ready - The VX4022A SWC Interface is compatible with vehicles that utilize a resistive type
SWC circuit. For SWC programming details, please see the operation manual.
•
Rear
Camera- The VX4022A is Rear Camera ready for vehicles equipped with the option. See wiring diagram for installation
details.
Disconnect the Battery
the ignition and remove the negative (-) battery cable prior to installation.
NOTE: If the VX4022A is to be installed in a car equipped with an on-board drive or navigation computer, do not disconnect
the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra
caution during installation to avoid causing a short circuit.
Replacing the Fuse
• When replacing the vehicles Radio fuse always use the proper rated replacement fuse. Using a fuse with an improper rating
re.
ISO-DIN Installation
Using the Cosmetic Trim Ring
NOTE: For proper operation of the CD/DVD player, the chassis must be mounted within 30° of horizontal. Make sure the unit is
mounted within this limitation.
A cosmetic trim ring is supplied with the head unit for installation exibility. This unit will t into most import dashes with little or
no modication to the dash board/cavity. Some US domestic vehicle dashes will accept a Double-DIN chassis, but there is
usually a small gap between the radio and dash piece after installation is complete. In this case, use the trim ring to conceal
any gaps that may be present.
Wiring Diagram
CAUTION! IMPOR
TANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully,
or have the installation handled by an experienced technician.
2
Black SiriusXM
-
Black
Black -
RIGHT FRONT
+)
RIGHT FRONT SPEAKER (-)
RIGHT REAR SPEAKER (+)
RIGHT REAR SPEAKER (-)
LEFT REAR SPEAKER (+)
LEFT REAR SPEAKER (-)
BATTERY 12V (+)
GROUND (-)
ACC / IGNITION (+)
POWER ANT & AMP (+)
BRAKE (-)
REVERSE (+)
LEFT FRONT SPEAKER (-PEAKER (-)
SPEAKER (
)
LEFT FRONT SPEAKER (+)
SPEAKER (-)
SPEAKER (+)SPEAKER (+)
WHITE
WHITE/BLACK
GRAY
GRAY/BLACK
PURPLE
PURPLE/BLACK
GREEN
GREEN/BLACK
YELLOW
BLACK
RED
ORANGE
BLUE
PINK
GREEN/WHITE
SWC A
SWC B
WHITE/PURPLE
WHITE/BROWN
BROWN/BLACK SWC GND
GPS Antenna (VX7022 Only)
HDMI
WWW.ASAELECTRONICS.COM
2602 Marina Drive, Elkhart, IN 46514
© 2015
Printed in China
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Jensen VX4025 Installation guide
-
Jensen VX7012 Installation guide
-
Advent ADVUNI300 Installation guide
-
Audiovox VX4025 Installation guide
-
Jensen VX-7010 Installation guide
-
Jensen VX4010 Installation guide
-
-
-
Jensen VX-3012 Installation Installation guide
-
Jensen VX3026 Installation guide