Before beginning assembly, please read these instructions thoroughly.
MZN112-T01
Side Body Mount (L)
Side Body Mount (R)
Body
Window Shield
R
THE FINEST RADIO CONTROL MODELS
INSTRUCTION SHEET
No.MZN112
90mm
Narrow
Tools : Must be prepared.
*Cutter Knife. *Nippers *Adhesive for plastic
*A Phillips Screwdriver
(Precision type or a small sized)
+ +
MAZDA RX-7 FD3S
For MINI-Z Racer MR-03N RM Type / MR-015 RM Type
White Body Set (Non Decoration)
2
For painting. use plastic model paints.
Attach each part as required.
Painting should be done before assembling.
Rear Mount Type (RM Type) Wheelbase (M)
1
Preparation of Chassis
Assemble the chassis as shown below.
Motor mounting position
Adjustment of Wheelbase / Front Tread
2
2 x 5mm
TP Screw
Replace the front body mount
with the one included in the set.
Front Body Mount
TP
Receiver Antenna
Bend the receiver antenna as shown below.
Receiver Antenna
2x5mm
Front body mount.
Chassis
Caution : Do not screw-in
excessively.
Antenna Cord
2mm
2x6mm
Caution : Do not screw-in
excessively.
< >
< Only for 27MHz >
30mm
Page is loading ...
-
1
-
2
Kyosho Mini-Z Racer MR-03N RM Type User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
Related papers
-
Kyosho MZN40 SKYLINE 2000 GT-R Racing User manual
-
-
-
-
-
-
-
-
-
