austriamicrosystems AG
is now
ams AG
The technical content of this austriamicrosystems application note is still valid.
Contact information:
Headquarters:
ams AG
Tobelbaderstrasse 30
8141 Unterpremstaetten, Austria
Tel: +43 (0) 3136 500 0
e-Mail: ams_sales@ams.com
Please visit our website at www.ams.com
AS1374– AN01- Demoboard
www.austriamicrosystems.com Revision 1.0 / 2011/11/15 1 - 7
Application Note: AN01- Demoboard
AS1374
200mA, Ultra-Low-Noise, High-PSRR, Dual Low
Dropout Regulators
Preliminary Application Note
ams AG
Technical content still valid
AS1374– AN01- Demoboard
www.austriamicrosystems.com Revision 1.0 / 2011/11/15 2 - 7
Table of Contents
1 FURTHER APPLICATIONS ................................................................................................................... 3
2 REVISION STATUS .............................................................................................................................. 3
3 GENERAL DESCRIPTION ..................................................................................................................... 3
4 HW- OVERVIEW:.................................................................................................................................. 4
4.1 AS1374 Demoboard jumper and device locations ....................................................................................... 4
4.2 AS1374 Demoboard 1V4 schematic ............................................................................................................. 4
4.3 AS1374 Demoboard 1V4 layout .................................................................................................................... 5
5 ORDERING INFORMATION .................................................................................................................. 6
6 COPYRIGHT ........................................................................................................................................ 7
7 DISCLAIMER ....................................................................................................................................... 7
AS3610
ams AG
Technical content still valid
AS1374– AN01- Demoboard
www.austriamicrosystems.com Revision 1.0 / 2011/11/15 3 - 7
1 Further Applications
Visit our home-page: http: //www.austriamicrosystems.com
2 Revision status
AS1374- AN01 - Demoboard Rev.: 1V0
AS1374 Demoboard – Layout Rev.: 1V4
AS1374 Demoboard – Schematic Rev.: 1V4
3 General Description
Connector Description
Label Name Description Info
A OUT1 Output Voltage 1 Output voltage range from 1.2V to 3.6V
B VDD Supply Voltage Supply voltage ranging from 2.0V to 5.5V
C OUT2 Output Voltage 2 Output voltage range from 1.2V to 3.6V
D GND Ground
Measurement Point Description
Label Name Description Info
E VDD Supply Voltage
Measurement Points
F OUT1/OUT2 Output Voltage 1/2
G GND Ground
H EN 1/2 Active High Enable Input
I Load 1/2 Load Jumper to put a resistive load to OUT1 / OUT2
J EN 1/2 Enable
ON: The AS1374 OUT1 / OUT2 is on.
OFF; The AS1374 OUT1 / OUT2 is off
No Jumper: Connect a valid enable signal
via external connector “H”.
Figure 1: Board Description
-
Connector
s
Figure 2
: Board Description
–
Measurement Points
ams AG
Technical content still valid
AS1374– AN01- Demoboard
www.austriamicrosystems.com Revision 1.0 / 2011/11/15 4 - 7
4 HW- Overview:
4.1 AS1374 Demoboard jumper and device locations
Listed below are the various connectors and jumpers.
4.2 AS1374 Demoboard 1V4 schematic
Ref.
Function Value Description Manufacturer Mfg. Order Nr.
C1 Input Capacitor 1µF 0805 / X7R / 16V Murata GRM21BR71C105KA01
C2 Output1 Capacitor 1µF 0805 / X7R / 16V Murata GRM21BR71C105KA01
C3 Output2 Capacitor 1uF 0805 / X7R / 16V Murata GRM21BR71C105KA01
U1 LDO ASSP 6-bump WL-CSP 1.47x0.97x0.6mm Austriamicrosystems AG AS1374-BWLT-1818
U1 LDO ASSJ 6-bump WL-CSP 1.47x0.97x0.6mm Austriamicrosystems AG AS1374-BWLT-1833
ams AG
Technical content still valid
AS1374– AN01- Demoboard
www.austriamicrosystems.com Revision 1.0 / 2011/11/15 5 - 7
4.3 AS1374 Demoboard 1V4 layout
Layout (top view)
Layout (bottom view)
ams AG
Technical content still valid
AS1374– AN01- Demoboard
www.austriamicrosystems.com Revision 1.0 / 2011/11/15 6 - 7
5 Ordering Information
Evalboard AS1374 version SAP number
AS1374-BWLT-1818 EB Rev1.4
Vout1 = 1.8V
Vout2 = 1.8V
990600335
AS1372-BWLT-1833 EB Rev1.4
Vout1 = 1.8V
Vout2 = 3.3V
990600336
ams AG
Technical content still valid
AS1374– AN01- Demoboard
www.austriamicrosystems.com Revision 1.0 / 2011/11/15 7 - 7
6 Copyright
Copyright © 1997-2011, austriamicrosystems AG, Schloss Premstaetten, 8141 Unterpremstaetten, Austria-
Europe. Trademarks Registered ®. All rights reserved. The material herein may not be reproduced, adapted,
merged, translated, stored, or used without the prior written consent of the copyright owner.
All products and companies mentioned are trademarks or registered trademarks of their respective companies.
7 Disclaimer
Devices sold by austriamicrosystems AG are covered by the warranty and patent indemnification provisions
appearing in its Term of Sale. austriamicrosystems AG makes no warranty, express, statutory, implied, or by
description regarding the information set forth herein or regarding the freedom of the described devices from
patent infringement. Austriamicrosystems AG reserves the right to change specifications and prices at any time
and without notice. Therefore, prior to designing this product into a system, it is necessary to check with
austriamicrosystems AG for current information.
This product is intended for use in normal commercial applications. Applications requiring extended temperature
range, unusual environmental requirements, or high reliability applications, such as military, medical life-support
or lifesustaining equipment are specifically not recommended without additional processing by
austriamicrosystems AG for each application. For shipments of less than 100 parts the manufacturing flow might
show deviations from the standard production flow, such as test flow or test location.
The information furnished here by austriamicrosystems AG is believed to be correct and accurate. However,
austriamicrosystems AG shall not be liable to recipient or any third party for any damages, including but not
limited to personal injury, property damage, loss of profits, loss of use, interruption of business or indirect,
special, incidental or consequential damages, of any kind, in connection with or arising out of the furnishing,
performance or use of the technical data herein. No obligation or liability to recipient or any third party shall arise
or flow out of austriamicrosystems AG rendering of technical or other services.
Contact Information
Headquarters
austriamicrosystems AG
A-8141 Schloss Premstätten, Austria
T. +43 (0) 3136 500 0
F. +43 (0) 3136 5692
For Sales Offices, Distributors and Representatives, please visit:
http://www.austriamicrosystems.com/contact
ams AG
Technical content still valid
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
austriamicrosystems AS1323 Application Note
-
Infineon TLS102B0MBBOARDTOBO1 Operating instructions
-
-
austriamicrosystems AS1109 User manual
-
-
-
Infineon Technologies TLE9844-2QX User manual
-
Fujitsu MB9B500A User manual
