Draper Brake Pipe Flaring Kit

This kit is designed to help you create professional-looking brake pipe flares. It is capable of producing both single and double flares, and can be used on a variety of pipe sizes. The kit includes a clamping bar, flaring tool, and a set of swaging dies.

The clamping bar holds the pipe in place while you are flaring it. The flaring tool is then used to create the flare. The swaging dies are used to create the double flare.

To use the kit, first insert the pipe into the clamping bar. Then, tighten the wing nuts to secure the pipe in place. Next, slip the flaring tool over the clamping bar and turn the “T” handle to create the flare. Finally, remove the flaring tool and insert the swaging die into the end of the pipe. Turn the “T” handle to create the double flare.