none 5612F2BXS Installation guide

Brand: none

Model: 5612F2BXS

Type: Installation guide

The none 5612F2BXS fountain is a stylish and durable addition to any outdoor space. With its heavy-duty concrete construction and powerful pump, this fountain is built to last. The fountain's unique design features a tall wall with a copper elbow and splash screen to prevent excessive splashing. The fountain is easy to set up and maintain, and includes a GFCI circuit for safety. Enjoy the beauty and tranquility of flowing water in your own backyard with the none 5612F2BXS fountain.

5612F2 SET UP INSTRUCTIONS

1) This fountain is simple to set up, but it includes two very heavy pieces! Therefore, make sure to

prepare a firm and level surface for the

fountain. With proper help, place your

fountain Basin on that surface. Make sure to

face the designed front of the basin toward

your primary viewing point.

2) Always follow local electrical codes

and connect to a safe GFCI circuit.

3) Install the thread-by-barb adapter into the

top of the pump and place the pump in the

center of the Basin. Slip the pump cord up

and drape it out the back middle of the basin.

4) Push one end of the water tube onto the

barb of the pump adapter. Drape the tube

out the back of the basin as well, along with

the pump cord.

5) With help, set the tall concrete wall

piece on top of the basin as shown. Make

sure to leave a little room in back for the tube

and pump cord to exit the basin.

6) Near the top of the wall front you will find

a pre-installed copper elbow. Directly behind

that – on the back side of the wall – install

the plastic barbed elbow. Then connect

the other end of the water tube to the barbed

end.

7) To prevent excessive splashing, place the

copper splash screen below the copper elbow

as shown.

8) Fill the basin with water, either from

behind where the tube exits or through the

vase portion of the wall.

9) Read your pump instructions. Then,

connect the pump to your power supply to

enjoy your fountain. If the pump does not

immediately begin working, there may be an

“airlock” within the impeller chamber. Simply unplug and plug in a few times and it should start.

10) Save this instruction and make sure to winterize according to details below. Csd

IMPORTANT – WINTER CARE

Winter ice build-up can cause damage to concrete statuary. Follow these tips to reduce winter weathering to your fountain:

* Disconnect power to pumps.

* Remove plugs / stoppers in all fountain bowls to open drains and let all moisture out. Keep drains open throughout winter.

* Place an absorbant material like burlap, blankets, etc. inside vases/bowls and cover all with a Henri fountain cover.

* Do not allow snow or ice to build up on or against the concrete. Remove snow before it turns to ice. Do not use salt or chemical ice

removers as these may damage concrete.

none 5612F2BXS Installation guide

none 5612F2BXS Installation guide

none 5612F2BXS Installation guide

Related papers

Other documents