Garmin Nexus Owner's manual

VW12

How to connect the wires to the solenoid at the HP-40 Linear Drive unit.

SOLENOID

Enlargement of the connector to the solenoid when taken apart

To be able to connect the solenoid to the Servo unit AP-1510

you have to open up the connector which is attached to the

solenoid. On the connector attached to the solenoid there is a

screw, untight the screw and take the connector apart.

You will now see three plints marked; 1, 2 and a ground sign

(see enlargement of the connector to the left).

No. 3 does not have any plint to connect wires at.

You are going to use plint no. 1 and 2 (the ground is not used).

Connect a wire to each plint (no. 1 and 2) and then connect the

wires to the AP-1510 according to the manual.

NOTE! It does not matter if the wire from plint no.1 from the

solenoid goes to plint no. 1 or 2 on the input (bypass) on Servo

unit. The same goes for the wire coming from plint no. 2 on the

solenoid.