Wolf 828022 Installation guide

Type
Installation guide

This manual is also suitable for

Wolf 828022 is a versatile countertop dual burner induction cooktop that offers precise temperature control, fast heating times, and energy efficiency. With its two induction burners, you can boil water quickly, sear meats perfectly, and simmer sauces gently. The cooktop's sleek design and easy-to-use controls make it a great addition to any kitchen.

Wolf 828022 is a versatile countertop dual burner induction cooktop that offers precise temperature control, fast heating times, and energy efficiency. With its two induction burners, you can boil water quickly, sear meats perfectly, and simmer sauces gently. The cooktop's sleek design and easy-to-use controls make it a great addition to any kitchen.

811065
E-Series Wall Oven/Microwave Trim Kit - MWTRIM30-2/S
815100 / Rev A / August, 2010
INSTALLATION PROCEDURE:
Cabinet Opening Preparations and Installation of Mounting Brackets
1. Locate properly grounded 3-prong receptacle within 4” (102mm) from the right side and 4” (102mm) up from
bottom of microwave oven cabinet.
Install the MW24 with a 120V, 60Hz, on a dedicated circuit. This outlet must be checked by a qualified
electrician to see if it is wired with correct polarity and is correctly grounded. A GFCI outlet is not rec-
ommended as this may cause product operation interruptions.
2. The floor of the opening should be constructed of
plywood strong enough to support the weight of the
oven and floor load (about 100lbs/.45kg). The floor
should be level for proper operation of oven. Be
sure to check local building code as it may require
that the opening be enclosed with sides, ceiling and
rear partition. The proper functioning of the oven
does not require this enclosure.
3. Locate mounting brackets and attach them with six
#6x1'' screws, making sure brackets do not extend
beyond front surface of the cabinet opening.
QTY
DESCRIPTION
1 Frame Assembly
1 Mtg Bracket, Rt
1 Mtg Bracket, Lt
6 Screw, 8-18x3/8'' Type B H/W/HD
6 Screw, 6-18x1'' TPG Type A
2 Screw, #8-15x1/2’ Truss HD
2 Framed SS Trim
QTY
DESCRIPTION
2 Small Glass Trim
2 Large Glass Trim
1 Bottom Ductwork MW24
2 Large Foam
2 Small Foam
1 Instructions
E-Series MW24
CONT
AINS:
Figure 1. Cabinet Preparation
Mounting
Brackets
Cabinet
Opening
Mounting
Screws
Page 1 of 2
NOTE: Make
sure brackets
don’t extend
beyond cabinet
opening.
NOTES:
Always pre-drill a pilot hole before installing screws to avoid damage to cabinet or trim kit hardware.
The location of the mounting bracket will control the height of the trim kit relative to the surrounding cabinetry
and microwave (See Figure 1).
811065
E-Series Wall Oven/Microwave Trim Kit - MWTRIM30-2/S
815100 / Rev A / August, 2010
Bottom Duct, Microwave & Decorative Trim Install
1. Center the bottom duct assembly in the opening.
Secure assembly to the base of cabinet opening,
using #8-15x1/2'' truss head screws (See Figure 2).
2. Plug power cord in. Carefully guide microwave into
opening, lining up feet of microwave with holes in
bottom duct assembly. NOTE: Verify that the
power cord is not pinched between the microwave
oven and the wall. Then lower microwave onto bot-
tom duct assembly (See Figure 2).
3. Finally, attach the frame assembly directly to the
cabinet opening, using four #6-18x1'' wood screws.
The inside edges of frame assembly should coin-
cide with the edges of the cabinet opening.
NOTE: Always pre-drill a pilot hole before installing
screws to avoid damage to cabinet or trim kit hard-
ware.
4. Adhere decorative trim panels to the side brackets,
so they are tight to the side and bottom of the frame
assembly (See Figures 3 & 4).
NOTE: The two pieces of foam tape are to be used
if gaps appear between the frame and the
microwave perimeter. If gaps are present, remove
the trim and adhere the foam tape to the microwave
where needed.
Figure 3. Decorative Trim / Unframed Assembly
Figure 4. Decorative Trim / Framed Assembly
Page 2 of 2
Large Glass
Decorative Trim
NOTE: Once
installed, trim will
sit tight to side
and bottom of
frame assembly
.
Framed
Stainless Trim
NOTE: Once
installed, trim will
sit tight to side
and bottom of
frame assembly.
Small Glass
Decorative Trim
Figure 2. Microwave Install in Cabinet Opening
Btm
Duct
Mounting
Screws
The feet of the microwave
will sit in these holes.
Frame
Assembly
  • Page 1 1
  • Page 2 2

Wolf 828022 Installation guide

Type
Installation guide
This manual is also suitable for

Wolf 828022 is a versatile countertop dual burner induction cooktop that offers precise temperature control, fast heating times, and energy efficiency. With its two induction burners, you can boil water quickly, sear meats perfectly, and simmer sauces gently. The cooktop's sleek design and easy-to-use controls make it a great addition to any kitchen.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI