Adjust handstrap
for snug fit
before folding
You are now ready to use your CN2 and handstrap. For help, see the
CN2 Handheld Computer User’s Manual (P/N 075464).
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel 425.348.2600
fax 425.355.9551
www.intermec.com
©
2005 Intermec Technologies
Corporation. All rights reserved.
CN2 Handstrap Instructions
*075465-002*
P/N 075465-002
CN2 Handstrap Instructions
The CN2 Handstrap (P/N 075400) gives you a convenient way to hold
the CN2 Handheld Computer. Simply place your hand under the
adjustable nylon strap and grasp the computer. When you use the CN2
for an extended period of time, the handstrap helps relieve hand stress.
This instruction sheet lists the parts contained in the handstrap kit and
describes how to install the handstrap.
Unpacking the Handstrap Kit
The handstrap kit contains this instruction sheet and these parts:
Adjustable
nylon strap
New battery
door
Screws (2)
Upper retaining
bar
Contents of the Handstrap Kit: When you unpack the handstrap kit, the upper
retaining bar may be attached to the nylon strap, and the screws may be
magnetically attached to the battery door.
Make sure you have all these parts. Contact your Intermec
representative if anything is missing or damaged.
Installing the Handstrap
Follow these instructions to install the handstrap. You will need a small
Phillips screwdriver.
To install the handstrap
1 Turn off the CN2, and place the CN2 face-down on a clean, flat,
stable surface.
2 Using the screws that came with the handstrap, attach the upper
retaining bar to the CN2.
Attach the uppe
r
retaining bar to
the CN2
3 Push down on the battery door latch, and pull up on the battery
door.
Battery
door
latch
4 Set the battery door aside. You cannot use this battery door with the
handstrap. You can discard this door or keep it as a spare for a CN2
without a handstrap.
5 Install the new battery door that came with the handstrap. Press
down on the battery door until it clicks into place.
Press down until
the latch clicks
6 Insert the handstrap under the bar on the new battery door. Make
sure the folded end faces down on the side of the bar closest to the
battery door latch.
Folded end
faces down
Insert handstrap
under bar
Battery latch
7 Fold the handstrap over and insert it under the upper retaining bar.
The hooks and loops on the handstrap are now facing up.
Hooks
Loops
Insert handstrap under
the upper retaining bar
8 Place your hand under the handstrap to adjust the fit. Then fold the
handstrap over and press down firmly to attach the hooks and loops,
as shown in the next illustration.
-
1
-
2
