2. KOAMTAC
  3. KDC470 SmartSled Barcode Scanner

KOAMTAC KDC470 SmartSled Barcode Scanner, KDC470/475 OTG General Universal SmartSled User manual

  • Hello! I am an AI chatbot trained to assist you with the KOAMTAC KDC470 SmartSled Barcode Scanner User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1. Attach the OTG USB Connect Head to the phone. (A)
4. Inspect the connection between the General Universal
SmartSled and previously installed OTG USB Connect Head.
To test the connection, attempt to charge your device via
USB or Charging Cradle - the device will begin charging if
the connection is successful. (C)
Remove the phone from the case by peeling off the top
edge of the General Universal SmartSled. Carefully slide
the phone up and pull the phone upward. Remove the
OTG USB Connect Head from the bottom of the phone. (D)
Adaptor Widow Direction
Phone Widow Direction
1 x KDC470/475 General Universal SmartSled
1 x Magnetic OTG USB Connect Head (Type C)
Type C OTG USB
Connect Head
GUA_AM_20201217
2. Check the pin arrangement as shown in the image below
because the OTG USB Connect Head is direction-sensitive.
/