WC-R4300-60-DBL
RESIN INSTALLATION GUIDE
Parts List
12B 12C 4D
Mark the position of the screw holes on the wall by
measuring the space between the centers of the
mounting brackets on the back of the vanity.
Vertical position (X) is decided by the purchaser -
remember to mark low enough to accommodate
the sink on the top of the vanity counter or it
will be too high when installed. Use a spirit level
to ensure the screws holes are horizontal.
Mark the screw position
Diameter 6mm
Depth 40 mm
Draw horizontal line
1
Tools List
(Tools not included)
Electric drill
Drill bit
(Ø8)
Pencil Screwdriver
Silicone Tape measure
Spirit Level
Prior to installation, please check recieved
items against the “Parts List.
Please report any missing items to your
retailer immediately.
Protect all surfaces from sharp objects,
high heat sources, direct prolonged
sunlight and chemical hazards.
Professional installation recommended.
1 Integrated Countertop and Sink
1 or 2 Mirrors
2 per mirror 2 per mirror
WC-R4300-60-DBL
RESIN INSTALLATION GUIDE
Attach vanity to wall by lowering onto
the mounting brackets
wall
3
Adjust the mounting attachment as required
Upper screw adjusts
vertical position
Lower screw
adjusts depth
4
12B
12C
4D
Insert the anchor into the screw hole for reinforcement.
2
adjust height
adjust laterally
adjust depth
Adjust hinges as required.5
WC-R4300-60-DBL
RESIN INSTALLATION GUIDE
6 7
silicone
8 9
Licensed professional installation is recommended.
These instructions are for mounting into studs or
other in-wall reinforcement, drywall alone is not
sucient to support wall-hung wanities. Other
installation techniques may require a licensed
professional.
Attach counter to cabinet with silicone sealant
applied to top of front and side cabinet edges.
Do not over-apply. Allow to dry for 24 hours
for proper curing.
Use a spirit level to ensure the vanity is level left to right.
Adjust if needed.
Use a spirit level to ensure the vanity is front to back.
Adjust if needed.
WC-R4300-60-DBL
RESIN INSTALLATION GUIDE
X
Diameter 8mm
Depth 40mm
Mark screw position
Draw horizontal line
10
12
11
2
2
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI