Play It Safe RPDN26 Driveway Net is a safety net designed to prevent children and pets from entering the driveway. It is made of a durable mesh material and can be installed with or without the included center post. The net is easy to install and remove, and it can be used on any type of driveway surface. When not in use, the net can be rolled up or folded for easy storage.
Here are some of the features and benefits of the Play It Safe RPDN26 Driveway Net:
- Prevents children and pets from entering the driveway
- Durable mesh material
- Easy to install and remove
- Can be used on any type of driveway surface
Play It Safe RPDN26 Driveway Net is a safety net designed to prevent children and pets from entering the driveway. It is made of a durable mesh material and can be installed with or without the included center post. The net is easy to install and remove, and it can be used on any type of driveway surface. When not in use, the net can be rolled up or folded for easy storage.
Here are some of the features and benefits of the Play It Safe RPDN26 Driveway Net:
- Prevents children and pets from entering the driveway
- Durable mesh material
- Easy to install and remove
- Can be used on any type of driveway surface
1
DRIVEWAY NET
PLAY IT SAFE
™
Model: RPDN26
Installation and Operation Manual
This product is not a life saving device. This is not a substitute for adult
supervision.
Read this manual completely prior to operating the Play It Safe Driveway Net. Keep
this manual for future reference.
Measure the driveway prior to installing the net to ensure the net will reach across
the entire driveway.
The net is not to be used as a fence or permanent barrier.
Ensure area is clear of underground plumbing or wiring prior to installation.
!
WARNING:
IMPORTANT:
IMPORTANT:
IMPORTANT:
CAUTION:
TABLE OF CONTENTS
List of Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Installation/Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
LIST OF COMPONENTS
(1) Stake/Nail (for pre-drilling)
(2) PVC Outer Post Sleeves
(2) Outside Posts
(1) Center Post
(1) Center Post Sleeve
(1) 26' x 36" Driveway Net
INSTALLATION
There are two ways to install the net: with the center
post (recommended) or without the center post.
Tools Required:
• Tape measure
• Rubber mallet or metal hammer with small
block of wood
• Chalk or non-permanent writing utensil
• 5/8" masonry bit (if using center post)
• Power drill (if using center post)
2
WITH CENTER POST
CAUTION: Drilling may cause damage to pavers.
Concrete or asphalt recommended for this
installation. Consult with professional prior to
drilling.
1) Measure and mark the center point at the end
of the driveway (Fig 1).
2) Drill a hole using a 5/8" masonry bit at
approximate 4 degrees angle, leaning the drill
back toward the street, parallel with either side of
the driveway (Fig 2).
3) Clear out the hole and place the Center Post
Sleeve into the hole.
4) Unroll the net with the center resting at the
measured mark on the driveway.
5) Guide the Center Post into the center sleeve of
the net and install the post into the Post Sleeve.
IMPORTANT: The net side should face the street
and the black sleeve should face the driveway. In
addition, the black material should be at the
bottom of the net, not the top (Fig 3).
6) Place an Outside Post into the net sleeve and
stretch the net toward the side of the driveway,
keeping it in line with the center post.
7) While keeping the net tight, move the end post
1-2 feet away from the street creating a funnel to
the center post. Mark the ground where the post
touches (Fig 1).
8) Using the Stake/Nail, make a hole in the
ground, taping the it into the ground and making
small circular motions to loosen the soil. The
hole should be angled away from the street and
the center post. This will help to keep the net tight
and the posts straight (Fig 4).
9) Tap the PVC Outer Post Sleeve into the hole
using a rubber mallet or a metal hammer and a
block of wood until it is flush with the ground. Do
not damage the end of the PVC. Slide the post
into the PVC sleeve (Fig 4).
10) Repeat steps 6 through 9 for the other side.
11) Ensure the net is all the way to the ground, so
that the black material is touching the ground or
even slightly further down to create a ramp into
the net (Fig 3).
WITHOUT CENTER POST
1) Measure and mark the center point at the end
of the driveway (Fig 1).
2) Unroll the net with the center resting at the
measured mark on the driveway.
3) Place an Outside Post into the net sleeve and
stretch the net toward the side of the driveway.
4) Mark the ground where the post will be
installed.
5) Using the Stake/Nail, make a hole in the
ground, taping the it into the ground and making
small circular motions to loosen the soil. The
hole should be angled away from the other side of
the driveway. This will help to keep the net tight
and the posts straight (Fig 4).
6) Tap the PVC Outer Post Sleeve into the hole
using a rubber mallet or a metal hammer and a
block of wood until it is flush with the ground. Do
not damage the end of the PVC. Slide the post
into the PVC sleeve (Fig 4).
7) Install the second Outer Post into the net
sleeve and pull the net tightly across the driveway,
marking its location. Repeat steps 5 and 6 for this
side of the net.
8) Ensure the net is all the way to the ground, so
that the black material is touching the ground or
even slightly further down to create a ramp into
the net (Fig 5).
3
Fig. 1
Fig. 4 Fig. 5
Fig. 2
Fig. 3
OPERATION
• Use the net when the designated area is in use,
remove the net when the area is not being used.
• Remove the end posts and lie them on the
ground, remove the center post second.
• Roll or fold the net for storage, posts can
remain in the net for easy storage.
• Do not leave net outside in extreme weather.
Store is safe place when not in use.
TROUBLESHOOTING
• Net is not tight:
o Move the PVC sleeves away from the center
of the driveway and/or angle the PVC
sleeves away from the center of the driveway.
• Loose PVC sleeves:
o Reposition the PVC sleeves into new soi
o Do not rotate the Stake/Nail as much when
pre-drilling the hole for the PVC sleeve.
• Object Rolling Under Net:
o Ensure the black material is on the bottom
of the net, not on top.
o Slide the net down so that the black
material is resting on the ground on all
sections of the net.
For assistance, please contact SmartPool at 732-
730-9880, M-F, 9am-5pm EST.
-
1
-
2
-
3
-
4
Play It Safe RPDN26 Driveway Net is a safety net designed to prevent children and pets from entering the driveway. It is made of a durable mesh material and can be installed with or without the included center post. The net is easy to install and remove, and it can be used on any type of driveway surface. When not in use, the net can be rolled up or folded for easy storage.
Here are some of the features and benefits of the Play It Safe RPDN26 Driveway Net:
- Prevents children and pets from entering the driveway
- Durable mesh material
- Easy to install and remove
- Can be used on any type of driveway surface
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
WarmlyYours WHCA-120-0043 Installation guide
-
Warmup Snow Melting Cable – WSM Installation guide
-
Mighty Mule Automatic Gate Opener System Installation guide
-
DIAMOND KOTE 127667-2 Installation guide
-
GTO SL-6100 Installation guide
-
Mendocino Forest Products 05350 Installation guide
-
Cozy BBT53 User manual
-
Coleman Power Steel Owner's manual
-
Noritz America GQ-C2859WX-FF US LP Operating instructions
-
