PAC BKGMK265 User manual

PAC
Brand
PAC
Model
BKGMK265
Type
User manual

This manual is also suitable for

CUSTOMER HELP LINE
USA 800-323-4329
GMK265 Mounting Kit
Cadillac
2007-14 ESCALADE
2007-14 ESCALADE EXT
2007-14 ESCALADE ESV
VEHICLE APPLICATIONS
©2015 AMERICAN INTERNATIONAL INDUSTRIES, INC.
TECH Ver. 9/15 PRINT Ver. 9/15
iGMK265
WWW.AIUS.NET
2500 East Francis Street Ontario, CA 91761, U.S.A.
USA Sales (800) 336-6500
NOTE: THIS INSTALLATION KIT REQUIRES
PROFESSIONAL INSTALLATION. MAJOR SUB-DASH
MODIFICATION IS REQUIRED TO FIT RADIO.
1. Carefully remove the center console where the cup holders are located
(panel removal
tool recommended). There are 4 clips holding it in place, two on each side.
2. Remove the trim panel located next to the top right side of the factory radio bezel,
above the glove box which has a vent mounted in it.
3. Carefully start unsnapping the dash bezel that surrounds the factory radio
and climate controls.
4. Remove the (6) 9/32 screws holding the factory radio in the sub dash.
5. Unplug all harnesses from factory radio and remove from dash
ISOBRK
ISOBRK
DASH DISASSEMBLY INSTRUCTIONS
DOUBLE DIN INSTALLATION INSTRUCTIONS
2 3
Fig B
ISOBRK
ISOBRK
Fig A
Remove shaded tabs
on left and right sides
of the brackets
(Right side not shown)
KIT ASSEMBLY INSTRUCTIONS
1. Insert pocket into lower section of the GMK265 brackets
2. Install brackets to rear of main frame using the (6) screws provided.
3. Insert ISO mountable radio between ISO mount brackets and loosely attach to sides
of radio using screws provided with radio when possible, or screws supplied with kit.
4. Using the main frame of the GMK265 as a guide, slide radio forward or backward
for desired look and then tighten screws to the radio.
NOTE: Attach a rear support bracket to the rear of the new radio and adjust as
necessary to support the weight of the radio. Suggested.
THIS INSTALLATION KIT REQUIRES PROFESSIONAL INSTALLATION.
MAJOR SUB-DASH MODIFICATION IS REQUIRED TO FIT RADIO.
Single ISO Mount Applications
Double DIN Mount Applications
See Fig B for bracket tab removal.
1. Install brackets to rear of main frame using the (6) screws provided.
2. Insert ISO mountable radio between ISO mount brackets and loosely attach to
sides of radio using screws provided with radio when possible, or screws supplied
with kit.
3. Using the main frame of the GMK265 as a guide, slide radio forward or backward
for desired look and then tighten screws to the radio.
NOTE: Attach a rear support bracket to the rear of the new radio and adjust as
necessary to support the weight of the radio. Suggested.
  • Page 1 1
  • Page 2 2

PAC BKGMK265 User manual

PAC
Brand
PAC
Model
BKGMK265
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents