samsara.com/support HW-IG41
The IG should be mounted on a 35mm
DIN rail inside a properly rated enclosure,
e.g. NEMA 4x.
To mount it, pull down the latch on the
bottom of the device.
Angle the unit and hook it onto the DIN
rail, angle it down and push the latch
back up to lock.
1 2
Industrial
Gateway
INSTALL GUIDE
RESET BUTTON
POWER LED
If installing a multiband antenna on the
enclosure, drill a ⅞" hole and wipe the
surface clean before routing the cables
and applying the double sided tape.
Connect all five labeled cables to the
respective ports on the IG41.
Connect IG to power, power plug denotes
positive and ground, use 18AWG wire.
Connect IG ground screw to chassis
ground.
43
Power LED will be blinking white on startup.
It will start flashing green when connecting
and turn solid green when connected.
If the LED turns yellow, a reboot is required.
If the LED turns red, please call into
support.
Create an account at cloud.samsara.com
and activate the IG by entering the serial
number found on the front of the unit and
back of the box.
Go to kb.samsara.com to finish setting up
your device.
5 6
samsara.com/support
cloud.samsara.com
Activate Devices
ABC9-DE9-FG9
Activate Samsara Hardware
WARNING – EXPLOSION HAZARD. DO NOT DISCONNECT WHILE THE
CIRCUIT IS LIVE OR UNLESS THE AREA IS FREE OF IGNITIBLE
CONCENTRATIONS.
AVERTISSEMENT – RISQUE D’EXPLOSION. NE PAS DÉBRANCHER
PENDANT QUE LE CIRCUIT EST SOUS TENSION OU À MOINS QUE
L’EMPLACEMENT NE SOIT EXEMPT DE CONCENTRATIONS
INFLAMMABLES.
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- français: Samsara IG41 Guide d'installation
Related papers
Other documents
-
Fujitsu S26361-F2748-L38 Datasheet
-
red lion DA 6UIN Module User manual
-
-
-
-
-
SolaHD SDU AC B Series, A272-353 Owner's manual
-
-
Perle IDS-305 Installation guide
-