EN
Bluetooth Headset
0RWRUROD MH011
1
EN
AT A GLANCE
the important bits, quick and easy
Charge(Type C)
LED Indicator
Multi-Function
Button (MFB)
Microphone
Microphone
Volume Down
Button
Volume Up
Button
Boom
open-on
close-off
EN
23
EN
CHARGE IT
let’s get you up and running
To charge your headset, plug the Type C cable
into the headset's Type C port and connect to
Type C power source.
Note: Fully charge the headset before you use it.
Tip: To save battery power, turn off the headset
when you’re not using it.
Caution: Your battery is designed to last the life
of your device. It should only be removed by a
recycling facility. Any attempt to remove or
replace your battery will damage the device, void
your warranty, and could cause injury.
Choose your most comfortable fit ear tip.
CONNECT & GO
let’s get you connected
EN
4
EASYPAIRTM
METHOD
Turn on Bluetooth on your device.
Turn on your headset and follow the voice
prompts.
Select “Boom3” from the smart phone
Bluetooth menu.
When the device and headset connect,
you’ll hear “connected”.
5
EN
COMFORT
what feels best on you
Wear
Right Ear Left Ear
Eartip
Earhook
EN
67
EN
BASICS
standard features, advanced quality
To…
answer a call
reject a call
end a call
on
off
change call
volume
mute or unmute
a call
short press MFB.
press volume down 2 seconds.
short press MFB
boom open( on
boom close( off
press the volume up and
volume down button
press volume down 2 seconds
during the call and press
volume up 2s to unmute.
EN
8
Notes:
• Some features are phone/network dependent.
• Using a mobile device or accessory while driving
may cause distraction and may be illegal. Always
obey the laws and drive safely.
Notes:
After one minute on a call or 20 minutes of
inactivity, the light stops flashing to conserve power,
but the headset remains on. Closing the Boom also
saves battery life.
9
EN
STATUS LIGHT
If light shows… your headset is…
EN
10 11
EN EN
12 EN 13 14 EN
To…
last track
next track
pause/play
pairing mode
reset
3-way call ongoing
reject incoming,
continue ongoing
press volume down 2 seconds
when headset is in music state.
press volume up 2 seconds
press MFB once to pause and
press again to play.
press MFB 5 seconds to enter
into pairing mode when headset
is in on mode.
press MFB and volume down
5 seconds.
press MFB once
press and hold volume down
double press MFB
power on
power off
pairing
on standby
charging
fully-charged
low battery
blue flashes 1 second.
red flashes 2 seconds.
red & blue flashes alternately.
blue flashes once every 5 seconds.
steady red.
steady blue.
red flashes once every 5 seconds.
ADVANCED
SECOND DEVICE
SETTINGS Help & more
Safety instructions for use
Do you use two phones? Or maybe a phone and a
tablet? Connect with both of them.
1 Pair the first device with your headset as normal
(see “CONNECT & GO” on page 4).
2 Turn off the Bluetooth® feature on the first device.
3 Now pair the second device with your headset as
normal.
4 Once paired, to connect with both devices simply
turn them on.
Restore Factory Settings:
Reset default factory settings on your headset.
Caution:
This feature erases all device pairing information
stored on the headset.
Multipoint:
Connect your headset to two devices.
To avoid hearing damage, keep the volume at a
moderate level. Avoid listening to music at loud
volume levels for prolonged periods of time as this
may cause permanent hearing damage or hearing
loss. Your hearing is delicate and highly sensitive
so please listen to your music responsibly. For
more information visit the Deafness Research
Foundation www.drf.org.
Don't use Boom 3 when it is unsafe to do so. For
example, while operating a vehicle, cycling,
crossing a road, or any activity which requires
your attention and ability to hear.
You should be aware of your surroundings and
use Boom 3 responsibly.
· Live Chat: Motorolastore.support
Note: If you’re watching video while using your
earbuds, your audio may be slightly out of sync
with your video.
Manufactured, distributed, or sold by Binatone Electronics
International LTD., official licensee for this product.
MOTOROLA and the Stylized M Logo are trademarks or
registered trademarks of Motorola Trademark Holdings,
LLC. and are used under license. Apple logo is a
trademark of Apple Inc., registered in the U.S. and other
countries. App Store is a service mark of Apple Inc.
Google Play and Android are trademarks of Google Inc.
All other trademarks are the property of their respective
owners. © 2020 Motorola Mobility LLC. All rights reserved.
Product ID: MH011
FCC ID: VLJ-MH011
IC: 4522A-MH011
15
EN
EN
16 17
EN 18 EN EN 19
,
Wear
Eartip
Earhook
Earpiece
pick incoming
call, put ongoing
call on hold.
end ongoing,
resume waiting
call
switch calls press MFB once
end current call double press MFB
