Strands ALASKA SNOW PLOW LAMP User manual

Brand
Strands
Model
ALASKA SNOW PLOW LAMP
Type
User manual

Strands ALASKA SNOW PLOW LAMP is a high-performance lighting solution designed to provide maximum visibility during snowy conditions. Equipped with an automatic heating lens, this lamp effectively melts snow and ice, ensuring a clear field of vision without manual intervention. Its durable construction and weather-resistant design make it ideal for use on snow plows, ensuring safe and efficient snow removal operations.

Strands ALASKA SNOW PLOW LAMP is a high-performance lighting solution designed to provide maximum visibility during snowy conditions. Equipped with an automatic heating lens, this lamp effectively melts snow and ice, ensuring a clear field of vision without manual intervention. Its durable construction and weather-resistant design make it ideal for use on snow plows, ensuring safe and efficient snow removal operations.

MANUAL
ALASKA SNOW PLOW LAMP
LED
Part no. 270708
www.strands.se
www.strandseurope.com
Contact us if you need support: [email protected] or +46(0)320-450450
READ THIS BEFORE INSTALLATION
READ ALL INSTRUCTIONS AND STUDY DIAGRAMS BEFORE INSTALLING YOUR NEW LIGHTS!
LEGAL MOUNTING
Check with state or local authorities for laws governing usage and proper mounting of your new lights.
TAKE CARE OF YOUR PRODUCT
Keep the product clean. Dirt on the lens and heat-sink may shorten the products lifetime.
We recommend using lukewarm water and alkaline degreasing.
Follow the degreasing instructions carefully and rinse off gently with cold or lukewarm water on low pressure.
WARNING!
Strong chemicals should not be used on the product. If you accidently get strong chemicals on the product, rinse off immediately, use
plenty of water so that no chemicals remain in any joint.
Some chemicals have a small amount of solvent in them, this can dissolve sealing adhesives and compromise the product's
waterproofness.
Some chemicals pull out liquid from plastic and rubber-based components, which makes the plastic or rubber brittle and bursts more
easily.
Be careful not to use high water pressure close up on the product.
If you use high water pressure at short distances, most products find it difficult to close out the water.
INSTALLATION
If there is a contact/connector on the product, it should not be cutted. If the connector is cut, the warranty is not valid.
If the product has loose cable and no connector. If the cable is shorter than 50 cm, the cable must not be cutted. If the cable is cut, the
warranty is not valid.
If the cable is longer than 50 cm, it is ok to shorten the cable, but not shorter than 50 cm.
If the cable is cut shorter than 50 cm, the warranty is not valid.
Tighten screws and bolts so that they do not loosen or chafe.
Do not tighten screws so hard that the protective bearings on the product breaks.
WARNING!
Do not use higher volts than the product description states.
This light becomes hot under continuous use. Don´t remove or touch the casing for at least 30 minutes after turning the lamp off.
Pin2 - RED = HIGH BEAM/HEATING LENS
Pin1 - BLACK = - TO CHASSIS GROUND
Pin6 - YELLOW = LOW BEAM/HEATING LENS
Pin4 - GREY = INDICATOR
Pin3 - GREEN = POSITION LIGHT
Alaska comes with a heating lens that provides
maximum visibility in any weather.
The feature is automatic, starts at five degrees
and keeps snow and ice away from the lens -
without any handling by the driver.
142,4mm
177,8mm
85,5mm200,4mm
  • Page 1 1

Strands ALASKA SNOW PLOW LAMP User manual

Brand
Strands
Model
ALASKA SNOW PLOW LAMP
Type
User manual

Strands ALASKA SNOW PLOW LAMP is a high-performance lighting solution designed to provide maximum visibility during snowy conditions. Equipped with an automatic heating lens, this lamp effectively melts snow and ice, ensuring a clear field of vision without manual intervention. Its durable construction and weather-resistant design make it ideal for use on snow plows, ensuring safe and efficient snow removal operations.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents