Tripp Lite TRIPP-LITE MODBUSCARD MODBUS Management Accessory Card for UPS Remote Monitoring and Control Installation guide

Type
Installation guide

The Tripp Lite TRIPP-LITE MODBUSCARD MODBUS Management Accessory Card for UPS Remote Monitoring and Control allows you to monitor and control your UPS system remotely via a PC using the MODBUS protocol. It supports various MODBUS functions, including reading coils, discrete inputs, holding registers, and input registers, as well as writing single coils and single registers. With RS-422/485 and RS-232 interfaces, it enables communication between the UPS and PC through either or both ports simultaneously. Three sets of 8 DIP switches allow for card ID, RS-232, and RS-422/485 configurations.

The Tripp Lite TRIPP-LITE MODBUSCARD MODBUS Management Accessory Card for UPS Remote Monitoring and Control allows you to monitor and control your UPS system remotely via a PC using the MODBUS protocol. It supports various MODBUS functions, including reading coils, discrete inputs, holding registers, and input registers, as well as writing single coils and single registers. With RS-422/485 and RS-232 interfaces, it enables communication between the UPS and PC through either or both ports simultaneously. Three sets of 8 DIP switches allow for card ID, RS-232, and RS-422/485 configurations.

Specifications
MODBUS Management Accessory Card for UPS
Remote Monitoring and Control
MODEL NUMBER: MODBUSCARD
Description
Tripp Lite's MODBUSCARD provides UPS systems with the functionality of communication with PCs via
MODBUS. Implements MODBUS RTU protocol. Provides MODBUS functions including Read Coils,
Discrete Inputs, Holding Registers, Input Registers, Write Single Coil and Single Register. Provides RS-
422/485 and RS-232 interfaces (PC communicates with UPS via RS-422/485 or RS-232 or both at the
same time). Three sets of 8 dipswitches support Card ID, RS-232 and RS-422/485 configurations.
Includes RS-422/485 and RS-232 communications ports. See manual for detailed setup instructions and
full set of functions and configuration options. Compatible with select SmartOnline UPS models only (The
MODBUSCARD should be listed within the "UPS Accessories" or "Power Management & Hardware"
sections of the compatible UPS product webpage).
Features
Tripp Lite's MODBUSCARD provides UPS systems with the functionality of communication with PCs via
MODBUS.
Implements MODBUS RTU protocol.
Provides MODBUS functions including Read Coils, Discrete Inputs, Holding Registers, Input Registers,
Write Single Coil and Single Register.
Provides RS-422/485 and RS-232 interfaces (PC communicates with UPS via RS-422/485 or RS-232 or
both at the same time).
Three sets of 8 dipswitches support Card ID, RS-232 and RS-422/485 configurations. Includes RS-
422/485 and RS-232 communications ports. See manual for detailed setup instructions and full set of
functions and configuration options.
Compatible with select SmartOnline UPS models only (The MODBUSCARD should be listed within the
"UPS Accessories" or "Power Management & Hardware" sections of the compatible UPS product
webpage).
Highlights
Internal MODBUS management
accessory card
Simple installation and setup
Implements MODBUS RTU
protocol
Provides RS-422/485 and RS-
232 interfaces
Package Includes
MODBUSCARD
Installation Guide
OVERVIEW
UPC Code 037332157065
1 / 2
Downloaded from Arrow.com.
© 2022 Tripp Lite. All rights reserved. All product and company names are trademarks or registered trademarks of their respective holders. Use of them does
not imply any affiliation with or endorsement by them. Tripp Lite has a policy of continuous improvement. Specifications are subject to change without notice.
Tripp Lite uses primary and third-party agencies to test its products for compliance with standards. See a list of Tripp Lite's testing agencies:
https://www.tripplite.com/products/product-certification-agencies
PHYSICAL
Shipping Dimensions (hwd / in.) 1.60 x 6.00 x 6.00
Shipping Dimensions (hwd / cm) 4.06 x 15.24 x 15.24
Shipping Weight (lbs.) 0.55
Shipping Weight (kg) 0.25
Unit Dimensions (hwd / in.) 0.600 x 2.350 x 5.280
Unit Dimensions (hwd / cm) 1.5 x 6.1 x 13.5
Unit Weight (lbs.) 0.11
Unit Weight (kg) 0.05
WARRANTY & SUPPORT
Product Warranty Period
(Worldwide) 2-year limited warranty
2 / 2
Downloaded from Arrow.com.Downloaded from Arrow.com.
  • Page 1 1
  • Page 2 2

Tripp Lite TRIPP-LITE MODBUSCARD MODBUS Management Accessory Card for UPS Remote Monitoring and Control Installation guide

Type
Installation guide

The Tripp Lite TRIPP-LITE MODBUSCARD MODBUS Management Accessory Card for UPS Remote Monitoring and Control allows you to monitor and control your UPS system remotely via a PC using the MODBUS protocol. It supports various MODBUS functions, including reading coils, discrete inputs, holding registers, and input registers, as well as writing single coils and single registers. With RS-422/485 and RS-232 interfaces, it enables communication between the UPS and PC through either or both ports simultaneously. Three sets of 8 DIP switches allow for card ID, RS-232, and RS-422/485 configurations.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI