Introduction

Thank you for purchasing the LINDY USB 3.0 SATA Adapter. This versatile adapter allows you to

connect your SATA disk drives to your computers USB 3.0 port, without the need for dedicated drive

housing.



Four HDD brackets with screws to stabilize the adapter



This manual

Features



Super Speed USB 3.0 Interface



Compliant to SATA Specification Rev. 2.6



Supports 2.5”, 3.5” and 5.25” SATA drives



One Touch Backup Function

2. Next connect the USB Adapter to an available USB 2.0 or 3.0 port on your computer.

3. After a short while you will see the Found New Hardware message and Windows will install the

drive.

4. Once Windows has finished installing your drive you will see Your new hardware is installed and

ready to use.

5. Go to My Computer and you will be able to see your newly installed drive.

Disconnecting (Safely Remove Hardware)

Windows

LINDY No. 43118

www.lindy.com

USB 3.0 SATA Adapter

Shielded cables must be used with this equipment to maintain compliance with radio frequency energy emission regulations and ensure a

suitably high level of immunity to electromagnetic disturbances.

FCC Warning

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.

may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular

 Increase the separation between the equipment and receiver

 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

 Consult the dealer or an experienced technician for help

You are cautioned that changes or modification not expressly approved by the party responsible for compliance could void your authority to

operate the equipment.

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation.

In 2006 the European Union introduced regulations (WEEE) for the collection and recycling of all waste electrical and electronic equipment.

It is no longer allowable to simply throw away electrical and electronic equipment. Instead, these products must enter the recycling process.

Each individual EU member state has implemented the WEEE regulations into national law in slightly different ways. Please follow your

national law when you want to dispose of any electrical or electronic products.

www.lindy.com