Dell Wyse 920279-01L Datasheet

Dell Wyse
Brand
Dell Wyse
Model
920279-01L
Category
Mounting kits
Type
Datasheet

This manual is also suitable for

Vertical Feet Kit Installation
Instructions
Use the following instructions to mount the thin client to the vertical feet kit.
1. Remove the four horizontal feet from the thin client by sliding the feet towards the back
panel.
2. Rotate the thin client until the power button is towards the top; slide the vertical feet
onto the spine at the bottom of the thin client until they snap in place. The first foot
snaps twice, once over the first locator position and then again at the second locator
position.
2
Note
For thin client cooling requirements, position the thin client so that the power
button to the thin client is on the top when installing in the vertical position.
Note
Leave at least 12.5 mm between the ventilation holes of the thin client and
any solid surface. An enclosed area must have a minimum of 150 square cm
of venting or other open area to maintain proper ventilation of the thin client.
883855-01 Rev. A
January 2005
  • Page 1 1
  • Page 2 2

Dell Wyse 920279-01L Datasheet

Dell Wyse
Brand
Dell Wyse
Model
920279-01L
Category
Mounting kits
Type
Datasheet
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents