Dell Wyse 920313-01L Datasheet
- Category
- Mounting kits
- Type
- Datasheet
This manual is also suitable for
Models Rx0L and Rx0LE
Horizontal Feet Kit Installation
Instructions
Use the following instructions to mount the thin client to the horizontal feet kit.
1. Remove the four (4) filler screws.
2. Position the feet to align the thumb screw holes on the feet with the mounting holes on
the thin client housing, and slide into place.
2
3. Insert four (4) thumb screws and snug the screws to hold the feet firmly in place (don’t
overtighten).
Caution
Do not place any objects on the thin client or block the vent holes under the
device.
Note
Leave at least 12.5 mm between the ventilation holes of the thin client and
any solid surface. An enclosed area must have a minimum of 150 square cm
of venting or other open area to maintain proper ventilation of the thin client.
883916-01L Rev. A
October 2008
-
1
-
2
Dell Wyse 920313-01L Datasheet
- Category
- Mounting kits
- Type
- Datasheet
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
HP t5630w Thin Client Reference guide
-
HP Compaq t5730w Thin Client Reference guide
-
HP t505 Flexible Thin Client Reference guide
-
HP t5325 Thin Client Reference guide
-
HP t510 Flexible Thin Client Reference guide
-
HP t5565 - Thin Client Reference guide
-
HP t5740 Thin Client Reference guide
-
-
HP st5742 Streaming Client Reference guide
-
HP t520 Flexible Thin Client Reference guide