Page1 OF 2Instruction # 52613 Hardware Pack # 52244
K&A Manufacturing
6703 Zinser Street
Schofield, WI 54476
Phone: 800.298.4351
Fax: 866.882.9475
www.raproducts.com
Version Dated:
10/16/14
Read all the instructions before beginning.
500/510CPU Holder
500CPU Holder 510CPU Holder
Free End
3
4
1
1
2
3
Steps 3 & 4
2
Page 2 OF 2
K&A Manufacturing
6703 Zinser Street Schofield, WI 54476
Phone: 800.298.4351
Fax: 866.882.9475
www.raproducts.com
Tools Required for Assembly:
Power Driver W/Adjustable Torque
#2 Phillips Head Driver Bit
Hardware Pack # 52244 Drawn Actual Size
ITEM # PART # DESCRIPTION QTY.
1 51529 10-32 x 5/8 Phillips Truss Head Machine Screw 4
2 52193 Steel CPU Strap Loop 1
3 50109 CPU Strap 1
4 Varies 500/510CPU Holder Base 1
Instruction # 52613
Step 1: Insert (2) machine screws 1 through the holes
at the top of the CPU holder base 5 . Thread them into
the lower set of inserts pre-installed in the vertical
surface and fully tighten.
Step 2: Place your CPU on the base 4 with the straps
hanging down. The CPU will rest on the strap where it
comes up through the slot in the base.
Step 3: Wrap the forward end of the strap 3 around
the CPU and attach it to the vertical surface with the
steel strap loop 2 . Use (2) machine screws 1
through the loop and into the set of inserts closest to the
top of the CPU.
Step 4: Buckle and tighten the strap 3 by pulling on
the free end as tight to the CPU as possible.
Steps 1 & 2
1
51529
52193
/
