Adaptec 5325301508 User manual

Brand: Adaptec

Model: 5325301508

Type: User manual

Adaptec 5325301508 is a SCSI card that can be installed on a Snap Server 4400. It is used to connect SCSI devices, such as hard drives, to the server. The card has a 68-pin VHDCI connector and supports Ultra320 SCSI. It is capable of transfer rates up to 320 MB/s. The card is also compatible with Adaptec RAID controllers.

Field Service Documentation 1

Snap Server 4400

not represent a commitment on the part of Overland Storage or any of its subsidiaries.

Snap Server

4400 SCSI Card

These instructions explain how to install a SCSI card on the Snap Server 4400.

Shutting Down the Server

Caution Shut down the server before you make any repairs. Improper shutdown may

lead to loss of data or physical harm.

1 To start the shutdown process, press the power button on the front of the server.

The green power LEDs remains lit until the

shutdown process is complete. Do not disconnect

the AC power cord while the LED remains lit.

2 After the power LED is off, disconnect the AC power cord from the back of the

server.

3 If you need to remove the server from a rack to access to the back panel,

disconnect the Ethernet cable(s).

Power button

Snap Server® 4400 SCSI Card Snap Server 4400

2 Field Service Documentation

not represent a commitment on the part of Overland Storage or any of its subsidiaries.

Removing the Top Cover

1 Grasp the top cover placing the thumbs on the release latches and the fingers

along the edge of the cover.

2 Press the latches inward toward the center and slide the front edge of the top

cover back about 1 inch.

3 Lift off the cover and set it aside.

Installing the SCSI Card

1 Press the release lever down and forward to release it.

Back of server

Field Service Documentation 3

not represent a commitment on the part of Overland Storage or any of its subsidiaries.

Snap Server 4400 Snap Server® 4400 SCSI Card

Using your thumb, slide the metal protective plate off as shown in the

illustration.

Put the protective plate in a safe place so you can use it to cover the hole if you

ever permanently remove the SCSI card.

3 Install the SCSI card.

Press firmly to until the card snaps into place, indicating that it is seated

properly in its slot. Avoid contact with metal surfaces on the card. Grasp or

press the edges only.

4 Pull the release lever back into place to secure the card.

Back of

server

Snap Server® 4400 SCSI Card Snap Server 4400

4 Field Service Documentation

not represent a commitment on the part of Overland Storage or any of its subsidiaries.

Replacing the Cover

1 Lower the top cover onto the server so the front edge of the cover is about 1 inch

from the edge of the bezel.

Caution Be sure to replace the top cover. Do not operate the server without the

top cover in place.

2 Slide the front edge of the cover all the way forward until it snaps into place.

Restoring Power to the Server

1 If you disconnected the Ethernet cable(s), reattach them to the server.

2 Connect the power cord.

3 Press the power button on the front of the server.

Power button

Adaptec 5325301508 User manual

Adaptec 5325301508 User manual

Adaptec 5325301508 User manual

Related papers

Other documents