2. Home
  3. Lighting
  4. Outdoor lighting
  5. Pro-Elec
  6. PEL00833

Pro-Elec PEL00833 Operating instructions

  • Hello! I'm your chat assistant. I have analyzed the instructions for the PRO-ELEC Garden Lamp model PEL00833. This document provides essential safety guidelines, installation steps, and maintenance recommendations. It highlights that the lamp is designed for outdoor use, requires two GU10 7W LED lamps, and has an IP44 rating. I am at your service if you have any questions about this document or the device described within.
  • What type of lamps are required for this garden lamp?
    What is the IP rating of this garden lamp?
    What is the recommended way to clean the garden lamp?
1
IMPORTANT SAFETY INFORMATION
Please read these instructions carefully before use and retain for future reference.
• When using electrical appliances basic safety precautions should always be
followed.
• Check that the voltage indicated on the rating plate corresponds with that of the
local network before connecting the appliance to the mains power supply.
Safety Information for Installation and Operation
• Avoid excessive force when installing.
• Always install on a surface that can support the weight of the xture.
Plastic Garden Lamp
Model: PEL00833
2
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area. Made in China. PR2 9PP
Man Rev 1.0
SPECIFICATIONS
• Clean only with a soft, dry cloth. Do not use any chemicals, abrasives or solvents
that may damage the product.
INSTALLATION
• Unscrew the retaining screw and remove the main
assembly from the wall mounting.
• Turn off or isolate the mains supply.
• Feed the supply wiring through the access point in the
wall mounting.
• Attach the mounting to the wall using a suitable mounting
method.
• Using an allen key, remove the top and bottom diffusers.
• Offer up the main assembly and connect the mains
supply wires to the terminal block.
• Connect the positive supply wire (brown or red) to the
terminal marked L.
• Connect the neutral supply wire (blue or black) to the
terminal marked N.
• Clip the terminal block into the wall mount and ret the
main assembly onto the wall mount and replace the
retaining screw.
• Fit 2x appropriate GU10 Max 7W lamps (not supplied)
into both top and bottom lamp holders.
• Ret the diffusers and secure the 4 allen screws in each.
• Restore the mains supply.
CLEANING AND MAINTENANCE
1
2
3
4
5
6 7
Voltage 220-240V~50Hz
IP rating IP44
Lamp type 2 x GU10 7W LED
/