2. AMG
  3. AMG2165B

AMG AMG2165B Instruction Sheet

  • Hello! I'm a chat assistant and I've read the AMG2165B Instruction Sheet. This document describes the rackmount video transmitter with TTL In/Contact Closure Out Data capabilities, and the 2160B fibre transceiver, including information on video, optical, and data connections, as well as LED indicators. I'm ready to answer your questions about the device and its specifications.
  • What type of video connector does the AMG2165B use?
    What type of optical connectors does the AMG2165B use?
    What is the purpose of the Data Connection?
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 1 of 2 DERA-00
AMG2165B
Instruction Sheet
AMG2165B Rackmount Video Transmit + TTL In/Contact Closure Out Data
Video Connection
Connectors ...........................75 ohm BNC Socket.
Input Impedance...................75 ohm terminated.
Input Level ...........................1 volt p-p nominal.
Frequency Response.............10Hz to 6MHz min.
Optical Connection
Connectors............................ST Style (2 off)
Opto Out Launch Power
50/125............................-20dBm. min.
62.5/125.........................-17dBm min.
Wavelength...........................850nm nominal.
Data Connection
Connector ............................. 9 Way D Type Socket
Pin No. Function
1 Relay Out Common
2 Relay N/C
3 Relay N/O
4 TTL In
5 TTL Ground
Dimensions
Height ...................................3U
Width....................................7HP
Depth ....................................205mm
2160B
POWER
TRANSCEIVER
FIBRE
SYNC
DATA
VIDEO
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 2 of 2 DERA-00
Mounting Details
The AMG2165B plugs into and is powered from the AMG2000 Subrack
Indicators
Power....................................Green – lit when unit powered
Video Sync ........................... Green – lit when video signal present BNC input.
Data Sync .............................Green – lit when data channel present.
(Note: this does not indicate the presence of actual data)
/