RoofZone 48586 Owner's manual

I have carefully reviewed the Assembly and Operating Instructions for the TIE DOWN ENGINEERING Corner Stabilizer model 48586. The document provides detailed steps for mounting the stabilizer to a ladder using a specific set of parts. I'm ready to answer any questions you may have about these instructions or the device itself.
How should the ladder be positioned before attaching the stabilizer?

How should the U-bolts be placed?

What is used to fasten the stabilizer to the ladder?

TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336

www.tiedown.com (404) 344-0000 Fax (404) 349-0401

011711,E1167

Corner Stabilizer #48586

Assembly and Operating Instructions

U-bolt

Corner

Stabilizer

# Description Qty.

1 U-Bolts 2

2 Corner Stabilizer 1

3 Mounting Brackets 2

4 Wing Nuts 2

5 End Caps 2

Assembly instructions

1. Lay the ladder ﬂat on the ground with the “Wall Side” down.

2. Lift the end of the ladder up and position the Corner Stabilizer in desired mounting

position (under to top rung) The ladder should rest in place over the stabilizer bar.

3. Place u-bolts (1) over the side of the ladder near the ladder rung, and over the

Corner Stabilizer (2) in a 45 degree angle. NOTE: Position the u-bolts so that they

straddle the ladder side rail and top ladder rung as shown above right.

4. Fasten the stabilizer (2) to the inside of the ladder using two mounting brackets

(3) and four wing nuts (4).

5. Hand tighten wing nuts (4).

6. Flip the ladder/stabilizer over and press the rubber end caps on the ends of the

stabilizer tube. Tap the caps on with a rubber mallet if needed to assure a tight ﬁt.

Instruction #08127