HQ Power VDL5DL2 User manual

VDL5DL2
Brand
HQ Power
Model
VDL5DL2
Category
Stroboscopes & disco lights
Type
User manual
VDL5DL2 - 1 - VELLEMAN
VDL5DL2 – DOUBLE 5” ROTATING DISCO LIGHT
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying this 5” rotating disco light! Read this manual carefully before bringing the device into service.
Make sure that the device was not damaged in transit. If the device is damaged, you should contact your dealer and
postpone installation of this device.
2. Safety Instructions
Protect this device against rain and moisture.
Unplug the supply cable before you open the housing.
• Damage caused by disregarding certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for the ensuing defects or problems.
• Do not switch the device on immediately if it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached room temperature.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage from sharp edges. Ask an authorised dealer to replace
the cord if necessary.
• Always disconnect the device from the mains when it is not in use or when you wish to clean it. Only handle the
power cord by the plug. Never pull out the plug by tugging the power cord.
• Do not look directly into the light source as sensitive people may go into epileptic seizure if they do.
• There may be some smoke or a particular smell when the device is activated for the first time. This is normal and
the smell will gradually disappear.
• Note that damage caused by user modifications to the device is not covered by the warranty. Keep the device
away from children and unauthorised users.
3. General Guidelines
• Only operate this device with the supplied power adapter. Do not use the VDL5DL2 outdoors.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device will be protected against extreme heat, moisture and dust. Respect a min.
distance of 50cm between the projector and the illuminated surface.
• Familiarise yourself with the functions of the device before actually using it. Do not permit operation by unqualified
people. Any damage that may occur will probably be caused by unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• Note that all modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, lamp
explosion, crash, etc. Using the device in an unauthorised way will void the warranty and may damage the device.
VDL5DL2 - 2 - VELLEMAN
4. Installing or Replacing a Lamp
Turn the plastic ball counter clockwise gently while holding the ring between the base and the ball. Remove the old
lamp and insert a new one, screwing it clockwise to fix it. Only install the lamp when the device is unplugged from the
mains. Replace the lamp if it is damaged but take care to let the lamp cool down before you do this.
Do not install lamps with a higher wattage than that for which the device was designed. Use two 240V/15W lamps,
E14 socket.
5. Installation / Operation
CAUTION: Make sure there are no inflammables within a radius of 50cm when you are mounting the device.
Connect the device to the mains.
Put the ON/OFF button in the ON-position. The device starts rotating at a steady pace. Put the ON/OFF button in the
OFF-position to deactivate the device.
6. Cleaning and Maintenance
1. All screws should be tightened and free of corrosion.
2. The housing, mounting supports and connections should not be modified or tampered with e.g. do not drill extra
holes in mounting supports, do not change the location of the connections.
3. The electric power supply cables should be undamaged. Have this device installed by a qualified technician.
4. The moving parts must show no traces of wear and tear and should be well-balanced.
5. Disconnect the device from the mains before cleaning it.
6. Wipe the device clean regularly using a moist and clean cloth. Do not use alcohol or solvents on the device.
7. The user should only replace a lamp when necessary (see also 4. Installing or Replacing the Lamp). Actual
repairs should always be handled by a qualified technician. Order any spare parts with your local dealer.
7. Technical Specifications
Power Supply 240Vac / 50Hz
Power Consumption 30W max.
Dimensions 345 x 180 x 200mm
Total Weight 825g
Lamp 2 x 240V / 15W, E14 socket
Max. Ambient Temperature 45°C
1. Light Ball
2. Light Base
3. Hanging Hook
4. Power Input
The information in this manual is subject to change without prior notice.
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10

HQ Power VDL5DL2 User manual

VDL5DL2
Brand
HQ Power
Model
VDL5DL2
Category
Stroboscopes & disco lights
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents