2. NPS
  3. CG44

NPS CG44 Instructions Manual

  • Hello! I've reviewed the Chair Guard Instructions document. This document details the assembly process for several models, including CG28, CG32, CG37, CG44, CG54, CG72, CG81, and CG96. The instructions highlight the proper alignment, tab direction, and screw securing method. I'm ready to answer any questions you have about the installation!
  • What tools are recommended for assembly?
    How many screws are included?
    How many screws should be used for each tab?
CHAIR GUARD INSTRUCTIONS
For All Model #s: CG28, CG32, CG37, CG44, CG54, CG72, CG81, CG96
Materials Included:
• 1- 1inch round tube Metal Chair Guard
• 6- 1inch pan-head Phillips screws
Recommended Tools: power tool with Phillips head bit
Assembly Instructions:
• Lay Chair Guard flat on surface edge of stage (back or side) with tabs facing
inward on the surface of the stage.
• The back of the Chair Guard should be aligned with the back of the stage
back.
• The Chair Guard should be centered on the stage assuring protection for
the entire length or width of the stage.
• Fasten screws with Phillips head shaped drill bit until the tab is laying flat
and flush with the surface of the stage. To ensure safety, use all 6 screws
provided with the Chair Guards, 2 screws for each of the 3 tabs on the Chair
Guard.
Chair Guard flush with
stage back or sides of
stage.
Chair Guard screwed with 2
screws per tab (2 screws each for
3 tabs, 6 screws total). Tabs
should lay flat on stage.
/