Yale KF102 wireless remote control allows you to arm and disarm your Yale alarm system from up to 70 meters away. It features a low battery indicator to remind you when it's time to replace the battery. The KF102 is easy to pair with your Yale alarm system. Simply open the battery cover, press the learn button on the remote and the learn button on your alarm system. When the device beeps twice, the pairing is successful.
Yale KF102 wireless remote control allows you to arm and disarm your Yale alarm system from up to 70 meters away. It features a low battery indicator to remind you when it's time to replace the battery. The KF102 is easy to pair with your Yale alarm system. Simply open the battery cover, press the learn button on the remote and the learn button on your alarm system. When the device beeps twice, the pairing is successful.
Remote Control Manual
Wireless range
If using as part of the Shed and Garage Alarm system, the range of these parts is a
minimum of 1 metre, up to a maximum of 70 metres.
System activity
Please note, when the red light is visible, the product is in processing mode and will not accept
further instruction (such as entering of your PIN code).
Operation
1. To pair the unit to the main Shed and Garage device MH105, open the battery cover and
press the Learn button. Take the Main Unit, remove the battery cover and also press
the Learn button on this unit.
When the device beeps twice, the pairing has been successful and the alarm can be
switched on and off via the remote.
2. If the red light keeps flashing, the battery is low and requires replacing.
NOTE: Please repeat this action for pairing the Door Contact also.
Battery precautions
• Use only CR2032 batteries.
• Be sure to follow the correct polarity when installing the batteries as indicated in the battery
compartment. Incorrect polarity may cause damage to the unit.
• Do not mix old and new batteries.
• If the alarm is not used for long periods of time, remove the batteries to prevent damage to
the unit or injury from possible battery leakage.
• Please only use alkaline batteries.
KKFF110022RReemmootteeccoonnttrroollooppeerraattiioonnmmaannuuaall
WWiirreelleessssrraannggee
If using as part of an extended system the range of these parts is a
minimum of 1 meter, up to a maximum of 70 meters.
SSyysstteemmaaccttiivviittyy
Please note, when the red light is on the product is processing, so no
operation will work (for example, you will not be able to enter your PIN)
Product diagram:
OOppeerraattiioonn::
1，Open battery cover，press learn button to send PIN code, select different models of alarms，open the battery cover and
press the learn button to learn the code from each other。When you heard the device beep twice, the network is successfully
build, and the alarm can be switched ON and OFF by remote control normally.
2，This device is a wirefree accessories designed to work with,a Master unit. Press NO/OFF to control the system
accordingly.
3, The red light keeps flashing, this is the‘low battery’indicator. Replace the unit’s batteries.
BBaatttteerryypprreeccaauuttiioonnss
When using this product follow these precautions at all times;
•Use only the appropriate size batteries
•Be sure to follow the correct polarity when installing the batteries as
indicated in the battery compartment. Incorrect polarity may cause
damage to the unit
•Do not mix old and new batteries
•If the alarm is not used for long periods of time, remove the batteries to
prevent damage to the unit or injury from possible battery leakage
•Do not recharge batteries not intended to be recharged. Always
follow the manufacturers directions
•Please only use alkaline batteries
LED
ON
OFF
LEARN
CR2032 Battery
1
2
3
4
5
MODEL NO: KF102
Trusted
every day
www.yalehome.co.uk
Security & Risk Communications Limited,
Parkway Business Centre, Ballymount, Dublin,
Ireland, 24
ASSA ABLOY Opening Solutions UK & Ireland
School Street, Willenhall
West Midlands, WV13 3PW UK
Version 1A
WARNING
Do not ingest the battery, Chemical Burn Hazard
(The remote control supplied with) This product contains a coin/button cell battery. If the coin/
button cell
battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
Keep new and used batteries away from children.
If the battery compartment does not close securely, stop using the product and keep it away from
children.
If you think batteries might have been swallowed or placed inside any part of the body, seek
immediate
medical attention.
Declaration of Conformity (RED)
Hereby, we, Dongguan Houjie Mosaic Electronics Factory declare that the radio equipment KF102/YSGA02-W is in
compliance with Radio Equipment Directive (RED) 2014/53/EU. The relevant harmonized
test standards are listed:
RF: ETSI EN 300 220-1V3.1.1 (2017-02), ETSI EN 300 220-2 V3.2.1 (2018-06)
EMC: ETSI EN 301489-1 V2.2.3(2019-11), ETSI EN 301489-3 V2.1.1(2019-03),
EMF: EN 62479:2010;EN 50663:2017
LVD: EN IEC 62368-1:2020+A11:2020
This product can be used in the European market without restriction, meet the
requirements of article 10(2) and 10(10)
Certificate holder：Dongguan Houjie Mosaic Electronics Factory
Shima Industrial Estate, Dajing, Houjie Town, Dongguan 523000, Guangdong, China
–
FCC Compliance Statement
This device has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in residential installations. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio and television reception.
However, there is no guarantee that interference will not occur in a particular installation. If this
device does cause such interference, which can be verified by turning the device off and on, the
user is encouraged to eliminate the interference by one or more of the following measures:
–Re-orient or re-locate the receiving antenna.
–Increase the distance between the device and the receiver.
–Connect the device to an outlet on a circuit different from the one that supplies power to the
receiver.
–Consult the dealer or an experienced radio/TV technician.
WARNING! Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with FCC Rules Part 15). Operation is subject to two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference that
may be received or that may cause undesired operation.
-
1
-
2
-
3
Yale KF102 wireless remote control allows you to arm and disarm your Yale alarm system from up to 70 meters away. It features a low battery indicator to remind you when it's time to replace the battery. The KF102 is easy to pair with your Yale alarm system. Simply open the battery cover, press the learn button on the remote and the learn button on your alarm system. When the device beeps twice, the pairing is successful.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Yealink BHM711 User guide
-
DewertOkin RF-TOUCH System Instructions
-
Essence WeR@Home Installation guide
-
ISOtunes IT-48 User manual
-
FMS 1:18 Chevrolet Chevy K-10 Scaler Rtr Car Kit User manual
-
Hunter ROAM Residential Light Commercial Remote Control System Owner's manual
-
Caterpillar CAT CS42DBBRONUN User manual
-
Burnside T400LR User manual
-
OttLite Wireless Charging LED Lamp User guide
-
ALC AHS616 User guide
