8
If you wish to make contact with us due to a
malfunction or in connection with an order,
please always quote the serial number (SN)
and the name of your device. Please enter
these data here and on the service sticker
delivered with the device (stick this to a highly
visible place or in your telephone diary).
SN
Device
- You can find these data on the certificate
of guarantee or on the original receipt, or on
the identification label on your device. The
identification label can be found to the left of
the left vegetable tray.
In the event of malfunctions please call
V-ZUG AG’s local service centre on the
freephone telephone number 0800 850 850
To avoid unnecessary fault reports, please
check the power supply is working properly
(Has the plug been plugged in? Is the fuse
intact?) before requesting a service technician .
Queries, orders, service agreement
For queries and problems of an administrative
or technical nature, as well as to order spare
parts and accessories, please contact the head
office in Zug directly, Tel. +41 (0)41 767 67 67.
At the end of the guarantee year, you have
the option to conclude a service agreement
for the maintenance of all our products. We
will be happy to send you the corresponding
documents.
REPAIR SERVICE
• Installtheapplianceawayfromheat
sources. Installation in a hot environment,
direct exposure to the sun or installation near
heat sources (heaters, radiators, cookers)
will increase power consumption and should
therefore be avoided.
• Ifthisisnotpossible,thefollowingminimum
distances must be respected:
•30cmfromcoalorparaffinstoves;
•3cmfromelectricand/orgasstoves.
• Fitthespacers(ifsupplied)ontherearof
the condenser positioned at the back of the
appliance.
• Installtheapplianceinadry,well-ventilated
place, and ensure it is level, using the front
adjustment feet if necessary.
• Cleantheinterior.
• Fittheaccessories.
Electrical connection
• Electricalconnectionsmustbemadein
accordance with local regulations.
• Voltage and power consumption are
indicated on the rating plate inside the
appliance.
• Regulationsrequirethattheappliance
be earthed. The manufacturer declines
all liability for injury to persons or
animals and for damage to property
resulting from failure to observe the
above procedures and reminders.
• If the plug and socket are not of the same
type, have the socket replaced by a qualified
electrician.
• Donotuseextensionleadsoradapters.
Disconnecting the appliance
It must be possible to disconnect the appliance
by unplugging it or by means of a two-pole
switch fitted upline of the socket.
INSTALLATION