Page is loading ...
Item # _____________________________
C.S.I. Section 11420
A2780
ISO9001
Vulcan-Hart Co.
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. 1-800-814-2028
502-778-2791 QUOTE & ORDER FAX: 1-800-444-0602
F-32482 (08-04)
MODELS: VSCX2 SERIES Regenerated Steam Convection Steamer on Cabinet Base
VSCX2 SERIES
REGENERATED STEAM SERIES CONVECTION
STEAMER ON CABINET BASE
SPECIFICATIONS:
Regenerated steam generator convection steamer, Vulcan-Hart
Model No. VSCX2. Two stainless steel cooking compartments
with coved interior corners. Each compartment accepts six
1" deep, three 2
1
⁄2" deep or two 4" deep 12" x 20" pans. 1
1
⁄4" drain
in each compartment. Heavy duty stainless steel "slammable"
doors can be opened and closed at anytime during the cooking
cycle. Steam shuts off when door(s) are opened. Compartment
controls include 60 minute dial timer with buzzer, green "ready"
and red "cooking" indicator lights. Convection steamer mounted
on 28" high base cabinet with stainless steel front full height
doors, slip-off stainless steel side and aluminized steel rear panel
with welded 6" stainless steel legs rear with ange foot and front
with bullet. Direct steam supply at 15 to 50 PSI with a ow of
200 lbs. steam/hr.
Exterior dimensions:
VSCX2-6: 24"w x 33"d x 60
1
⁄2"h.
VSCX2-10: 24"w x 33"d x 68
1
⁄2"h.
NSF listed. U L listed. Meets ASME code.
■ VSCX2-6 6-pan capacity
■ VSCX2-10 10-pan capacity
STANDARD FEATURES
■ Two stainless steel cooking compartments with coved interior
corners. Each compartment accepts:
- 1" deep pans (6 - VSCX2-6)(10 - VSCX2-10)
- 2
1
⁄2" deep pans (3 - VSCX2-6)(5 - VSCX2-10)
- 4" deep pans (2 - VSCX2-6)(3 - VSCX2-10)
■ 1
1
⁄4" drain in each compartment.
■ Heavy duty stainless steel "slammable" doors can be opened
and closed at anytime during the cooking cycle. Steam shuts
off when door(s) are opened.
■ Compartment controls include 60 minute dial timer with buzzer,
green "ready" and red "cooking" indicator lights.
■ Convection steamer mounted on 28" high base cabinet with
stainless steel front full height doors, slip-off stainless steel
side and aluminized steel rear panel with welded 6" stainless
steel legs rear with ange foot and front with bullet.
■ Direct steam supply at 15 to 50 PSI with a ow of 200 lbs.
steam/hr. Includes high pressure limit control and 15 psi safety
relief valve, low water control with automatic ll and blowdown.
■ One year limited parts and labor warranty.
OPTIONS
■ Stainless steel cabinet back.
■ Correction facility package:
a. Security type tamper resistant fasteners with tack welds.
b. Control cover with hasp (lock by others).
c. Cabinet door with hasp (lock by others).
■ Step down transformer for control circuit if higher than
120 volts.
■ Second year extended limited parts and labor warranty.
ACCESSORIES
■ Water lter system.
■ Wire rack.
■ Pressure reducing valve.
■ Ball oat trap.
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. 1-800-814-2028
502-778-2791 QUOTE & ORDER FAX: 1-800-444-0602
NOTE: In line with its policy to continually improve its products, Vulcan-Hart Company reserves the right to change materials and
specications without notice.
F-32482 (08-04)
VSCX2 SERIES
REGENERATED STEAM SERIES CONVECTION
STEAMER ON CABINET BASE
DIRECT STEAM DATA:
Steam supply to the regenerated steamer must:
1. Maintain a steady 15 to 50 psi ow under operating conditions.
2. Have a minimum ow rate of 125 lbs. per hour, dry steam.
3. Be adequately trapped to provide dry steam. (See ball oat trap.)
4. Provide a service shut-off valve.
WATER QUALITY STATEMENT:
The fact that a water supply is potable is no guarantee that it is suitable
for steam generation. Your water supply must be within these general
guidelines:
SUPPLY PRESSURE 20 - 80 psig
HARDNESS* less than 3 grains
SILICA less than 13 ppm
CHLORIDE less than 30 ppm
pH RANGE 7-8
* 17.1 ppm = 1 grain of hardness
Other factors affecting steam generation are iron content, amount of
chloridation and dissolved gases. Water supplies vary from state to state
and from locations within a state. Therefore it is necessary that the local
water treatment specialist be consulted before the installation of any
steam generating equipment.
SERVICE CONNECTIONS:
Steam Supply:
3
⁄4" NPT for 15 - 50 psi direct steam.
Electric Connection for Controls: 120/60/1, 300 watt maxi-
mum power supply with grounding wire required. (For other
than 120 volt supply, consult factory for location of this
connection.)
Drain: Condenser box, compartment and boiler, 2" NPT.
(Provide an open air gap type drain within 12" of condenser
box. Do not connect solidly to any drain connection.)
Cold Water Connection:
3
⁄8" NPT for boiler feed. Inlet water
pressure between 20 and 80 psi.
Cold Water Connection:
3
⁄8" NPT for condensate box. Inlet
water pressure between 20 and 80 psi.
Water: For swing faucet, (single) (dual) temperature
1
⁄4" IPS
tailpiece.
Steam Take-Off Connection:
3
⁄4" NPT.
NOTE:
• Dimensionswhichlocatetheaboveconnectionshaveatoleranceof
+ or -3" (+ or -77 mm).
• Installation of backow preventers, vacuum breakers and other
specic code requirements is the responsibility of the owner and
installer. It is the responsibility of the owner and installer to comply with
local codes.
• Thisapplianceismanufacturedforcommercialinstallationonlyand
is not intended for home use.
/