1.
UltraSonic Acousc Panels should be placed a minimum of 16” from the ceiling and
floor, allowing for both aesthec and performance advantages. When choosing placement,
the most effecve areas are the first points of sound reflecon. An example includes wall
surfaces that directly receive sound from a speaker. Be sure to include corner placements in
your design, as these areas prove especially effecve.
Installaon Instrucons:
Sound control applicaons can vary by room shape, size, and usage. The informaon listed
below is a general purpose guide, intended to offer broad spectrum advice. A more
detailed guide can be found online at www.bondedlogic.com.
2.
Once you have decided on placement of your panels, prepare the panels for mounng.
The back of each panel has 2 keyhole shaped cutouts. Take some measurements, nong the
posion of the keyholes as they relate to the top edge of the panel. Hold the panel against
the wall, marking the top edge with a pencil or other erasable material. Using the previous
measurements, mark the areas where you will install the picture hangers of nails. The
picture hanger or nail will be used to affix the panel to the wall.
3.
Now that your panels and the wall surface are prepared for mounng,
posion the frame against the wall so that the picture hangers/nails in the wall meet the
keyholes in the panel. Now that your panels have been installed, relax and enjoy improved
acousc condions within the space that they are mounted!