Interact-TV Microfighters AGE 12+ User manual

Type
User manual

This manual is also suitable for

Do not touch the running propeller!
Adult supervision is required!
1.Propeller
2.Horizontal tail
3. Wing
4.Charge port
5.ON/OFF Switch
AirRage Series and MicroFighters are registered
trademarks of Interactive Toy Concepts © 2007
All Rights Reserved. Manufactured by and distributed
by Interactive Toy Concepts Ltd. Conforms to Safety
StandardsASTM F963-03 Regulatory Requirements.
Products and colors may vary. MADE IN CHINA.
Please Note:
MicroFighters is an advanced aircraft
that uses sophisticated onboard technology
unlike any found in similar vehicles. Even
experienced pilots should read the full contents
of this manual carefully to receive the
most from your flying experience.
Web site: www.interactivetoy.com
PLEASE! DO NOT RETURN THIS
PRODUCT TO ANY RETAIL STORE!
PLEASE! DO NOT RETURN THIS
PRODUCT TO ANY RETAIL STORE!
For any questions or problems with this product please contact us at:
Email: info@interactivetoy.com
Phone: Outside North America: +1 416 444 6873
Inside North America: 1 866 214 2220
Address: Interactive Toy Concepts
1192 Martin Grove Road
Toronto, Ontario, Canada
M9W 5M9
IMPORTANT SAFETY INFORMATION
Do not modify your MicroFighters! Do not point the antenna directly at the plane! Do not use in strong winds, use only in
VERY mild conditions! Do not use in rain, snow or around heavy debris! Do not use near electrical lines! Do not use around
smoke or flames! Do not use around water! Do not use around electricity! Do not use in crowded areas! Do not use around
air conditioning! Do not use around air vents! Do not use around ceiling fans! Do not use around large obstacles! Do not use
in very small spaces! Do be conscious of changes in your area! Any changes or modifications to this product are strictly
prohibited and will void product warranty. Keep moving propellers away from eyes, hands, hair and loose clothing. Always turn
off your MicroFighters and transmitter when not in use. Always remove batteries from transmitter during storage. Always place
transmitter with NEW alkaline batteries for optimal performance. Keep your Pilot’s manual in a safe place for future use. Only
use the provided charger included with the MicroFighters to charge the lithium polymer battery installed in the MicroFighters.
IMPORTANT BATTERY INFORMATION
Use only batteries recommended in this instruction manual. Do not mix old and new batteries.
Battery installation should be performed by an adult. Be careful to install the batteries with the correct polarity, as indicated.
Do not use rechargeable batteries. Do not mix alkaline, standard, lithium, rechargeable, or different types of batteries.
The supply terminals are not to be short-circuited. Exhausted batteries are to be removed as they will hinder performance.
Never leave a battery unattended while it is being charged. Never leave a battery unattended in the presence of children.
MicroFighter charging time will increase with usage as the condition of the AA cells diminish. Battery performance may
greatly influence flight characteristics. MicroFighter’s Li-Po rechargeable battery is not replaceable.
MicroFighter takes 6 AA battery (not included).
FCC NOTE: U.S. ONLY
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may
not cause harmful interference. 2) This device must accept any interference received including interference that may cause
undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These Limits are designed to provide
reasonable protection against harmful interference in a residential installation. This generates, uses and can radiate radio
frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try and correct the interference by one or more of the following measures: - Reorient or relocate the
receiving antenna - Increase the separation between the equipment and receiver - Connect the equipment to an outlet on a
circuit different from that to which the receiver is connected - Consult the dealer or an experienced radio/TV technician for help.
Limited 30-day warranty
This product is warranted by Interactive Toy Ltd. against manufacturing defects in material and workmanship
under normal use for thirty (30) days from the date of purchase.
This radiocommunication device complies with all the requirements of Industry Canada Standard RSS-310.
Operation is subject to the following two conditions: 1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation.
Field Strength and measurement distance: 27.145MHz –
54.95 dBµV/m
at 3 meters. 49.860MHz - 63.86 dB
µ
V/m at 3 meters.
Industry Canada Notice: Canada only.
Ce dispositif de radiocommunication rencontre toutes les exigences de la norme CNR-310 d'Industrie Canada. Son fonctionnement est
sujet aux deux conditions suivantes: 1) ce dispositif ne doit pas causer d'interférences nocives et. 2) ce dispositif doit accepter toutes les
interférences reçues, y compris les interférences susceptibles de provoquer un fonctionnement indésirable.
Puissance du champ et distance: 27.145mHz 54.95 dBµV/m à 3 mètres. 49.860mHz
63.86 dB
µ
V/m
à 3 mètres.
Avis d'Industrie Canada: Canada seulement
12
Lithium Polymer
Rechargeable Batteries
must be recycled or
disposed of properly.
IM-44005-70125-RSUS
Thank you for purchasing the MicroFighters, the world’s smallest and most progressive digital
proportional radio control aircraft. To insure safe and reliable operation, please read the entire
contents of this manual before removing the aircraft from its package.
PACKAGE CONTENTS
•MicroFighter
•Transmitter
•Antenna
•Instruction manual
•Landing gear
•Spare Propeller
1PC
1PC
1PC
1PC
1PC
2PCS
MICROFIGHTERS
TRANSMITTER
1. Throttle control
2. Steering control
3. Charging lead compartment
4.Antenna
5. Steering Trim knob
6. Power LED “Red”
7. Charging LED “Green”
8. ON/OFF switch
1
2
3
4
5
6
7
8
Parts Index
TRANS
TRANS
1
2
5
4
To prevent damage during
shipping, your MicroFighters
is securely fastened in the
package. Please insure that
all tie downs and fastening
locations have been unfastened
before attempting to remove the
aircraft from its package.
BEFORE FLYING
1. Use a Phillips head screw driver (cross head) to loosen
screw and remove cover .
2. Insert 6AA batteries in the correct polarity as indicated
inside the battery door cover.
3. Place cover back and re-tighten screw .
4. Screw antenna in place.
CHARGING THE MICROFIGHTERS
1. Make sure the power switch of the MicroFighters is
in the OFF position. NOTE: Always switch
OFF the plane after flying!
2. Make sure the controller antenna is collapsed to
avoid breaking it while not flying and to prevent
accidentally interfering with another RC aircraft
on the same frequency.
3. Remove the charge Lead on the transmitter and
insert it into the charge port on the MicroFighters.
NOTE: Always insure the lead is in the correct orientation.
4. Turn the transmitter switch to the ON position.
5. Green LED will blink indicating plane is now being charged.
6. Charge the MicroFighter fully which typically takes about 30min.
7. Green LED will stop blinking and light steadily, indicating that the plane is fully charged.
8. Remove Lead and place back inside storage compartment.
9. Turn transmitter OFF.
10. If you forget to turn off the transmitter and are not moving the control sticks, after 3 minutes
the Red LED will start blinking to remind you to turn it off!
NOTE: The MicroFighters will enter to sleep mode if idle over 3 minutes. Turn off and on the power for reset to normal.
Unlike other types of re-chargeable batteries, Lithium Polymer re-chargeable batteries do not require a full charge for operation.
However it is necessary to FULLY charge on the first flights for best results. *Shorter Charges = Shorter Flight Times.
Precaution: This product is design to operate in altitude below 4000ft! If the operation geographic environment is over the designed altitude,
The flight time may be degrading and the product may not function correct.
TIP:TIP:
7
8
When the plane is coming
towards you it appears to
turn in the "wrong" direction.
But if you imagine yourself
in the pilots seat, the model
is in fact turning correctly.
Try turning your back to the
aircraft and looking over
your shoulder.
Trouble shooting
SYMPTOM CAUSE CORRECTION
Propeller not rotate. ON/OFF switch is “OFF. Set switch to “ON” Position.
Low battery. Recharge battery.
Circles and descends after take off Trim knob requires Adjustment. Adjust the trim knob.
Can’t create lift MicroFighter not facing the wind Point MicroFighter into the wind
Unable to stay in the air Not enough power Recharge MicroFighter
Poor response to transmitter Frequency interference may occur Change location
near high voltage lines, transformers
and some large buildings
Difficult to control Stong wind Only fly during extremely calm
conditions or indoors
Loss of control Another controller on the same Change location
frequency is being operated in
the same vicinity
Controller out of range from vehicle Ensure the antenna is fully
extended and reduce distance
Landing gear bent landing gear may bend on impact Remove landing gear from
(This will not affect flight performance) plane and bend back into
position
Landing gear will not Damage occurred during impact Use small amount of clear
stay inside plane insert household tape to hold landing
gear in place.
NOTE: In the event that your MicroFighter sustains damage during impact, the problem
may be easily remedied by simply applying clear household tape to the damaged area.
Pre-Flight
• Do not touch the running propeller!
Adult supervision is required!
Always fly your aircraft in a large grassy area free of trees and other obstructions.
This will help protect your MicroFighter during impact.
• The MicroFighter was designed for very stable outdoor flying with wind conditions not to
exceed 7 KPH / 4mph. If you can feel the wind, DO NOT FLY!
• Make first flights with the landing gear on to help stabilize the flight and simplify the control
of this sensitive and maneuverable aircraft. After you have gained experience you can try
flying with the Landing gear removed!
• Your MicroFighter can be flown with or without Landing gear. In addition to enabling realistic
takeoffs and landings from smooth surfaces, the landing gear has the additional function of
slightly degrading the performance of this sensitive aircraft and also making it more stable
and easier to control smoothly, especially for beginners. It is strongly recommended that you
make all first flights WITH the Landing gear on AND to use a normal hand-launch over grass.
Notes: ONLY after you have gained experience should you consider a ground takeoff.
After you have advanced to the Pro Mode you can remove the stabilizing landing gear to do
wild maneuvers just like a full-size jet fighter!
Flying your MicroFighters
1. Switch the MicroFighter to the “ON” position. (1)
2. Turn transmitter switch to “ON” position. (2)
The red LED will light steadily. (3)
3. Fully extend the antenna. (4)
4. Move throttle control (left control stick) fully forward and
back to activate the transmitter. (5)
5. Make sure trim knob is centered with arrow pointing up. (6)
6. Push throttle control forward to half (middle) before
launch for FIRST flights.
7. Hold the nose of the MicroFighter with two
fingers to launch. (7)
8. Launch the MicroFighter as straight and level as possible;
always launch gently INTO the wind. (8)
9. Add throttle gently while adjusting the steering trim knob
on the transmitter.
10. Adjust trim Left when the MicroFighter turns Right.
11. Adjust trim Right when the MicroFighter turns Left.
12. Repeat steps (10) and (11) several times to make sure
your MicroFighter travels in a straight line.
Control Reversal
Advanced Flight Tehniques
MicroFighter is designed to make sharper and tighter turns as you reduce the throttle
power! Maximum turning will be during gliding. Control is thus less sensitive during
full throttle.
Sharp turns can be performed by quickly reducing throttle power to pitch the nose up
and to increase control sensitivity. Then while holding the right stick for a turn, you can
precisely control the amount or radius of the turn with the “LEFT” (throttle) stick: pushing
forward on the LEFT stick widens the turn; pulling back the “LEFT” stick for tightens the
turn. The left stick functions as an ELEVATOR control in this case!
Once the inside wing begins to bank a little move right stick back to center.
The MicroFighter will maintain the turn by itself; push right stick in the opposite
direction to straighten out.
NOTE: Your MicroFighter is designed to self-stabilize automatically when power
is reduced. In an "emergency" situation in which the plane is out of control,
quickly pulling the left throttle stick ALL the way back to stop the motors will
let the plane save itself and not crash!
To land your MicroFighter direct it INTO any slight wind and decrease throttle for slow
and steady descent. For perfect landings on smooth surfaces with the landing gear
however, land WITH the wind in the same direction it is blowing for a gentle touchdown.
To let your MicroFighter take off from any smooth surface allowing about 17 m / 50 ft takeoff run
and even more clear space for climb out, point it INTO any slight wind and give full power while making careful steering
corrections. Practice with your MicroFighter until you are confident and skilled enough to cancel the restricting
feature of Easy Mode and use the Pro Mode. To switch over to Pro Mode: BEFORE you turn on the controller, hold the
RIGHT stick hard over to the right. Then turn on the controller while still holding the RIGHT stick to the right. You can
release the right stick and the Red LED will blink three times indicating you have activated Pro Mode and deactivated
the Easy Mode intervention! Move the LEFT stick forward and back once to enable the controller as before.
2 4
6
5
3
ON
1
  • Page 1 1
  • Page 2 2

Interact-TV Microfighters AGE 12+ User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI