Power Fist 8630055 Owner's manual

V 4.0 24 in. Power Sweeper Drive Belts 8630055

SPECIFICATIONS

Contents 1x 8PJ685 Drive Belt (98), 1x 8PJ620 Drive Belt (99)

Use With

Power Sweeper 8617409

ASSEMBLY & INSTALLATION

DISASSEMBLY

When this manual refers to a part number, it refers to the included Parts List in the manual of the power

sweeper 8617409.

WARNING! Drain all fluids from the engine before performing any maintenance to the unit.

1. Loosen the M6*12 hex bolts on both sides of the cover plate with a 10mm wrench. Remove the

cover plate.

2. Loosen the M8*20 hex bolt on both sides using a 6mm dog wrench.

3. Move the tensioner stand (56) away.

4. Loosen the M8*20 hex bolt and remove the two belts.

24 in. Power Sweeper Drive Belts

Visit www.princessauto.com for more information 1

8630055 24 in. Power Sweeper Drive Belts V 4.0

ASSEMBLY

1. Align the PJ620 belt onto the lower pulley and then place the other end around the pulley on the motor.

2. Replace the tensioner stand (56) by aligning the holes and secure with the M8*20 hex bolts and

washers. Tighten with a 13mm wrench.

3. Align the PJ685 belt onto the other lower pulley. Place the other end of the belt on the smaller pulley

and attach to the engine shaft. Tighten the 5/16-24 UNF bolt with a 13mm wrench.

4. Secure the tensioner stand (56) onto the frame with the M8*20 bolts. Tighten the bolts and replace the

cover plate.

5. Replace and tighten the M6*12 hex bolts with a 10mm wrench.

2 For technical questions call 1-800-665-8685

Page is loading ...

Download PDF