FMI CSK-8DM Operating instructions

Brand: FMI

Model: CSK-8DM

Type: Operating instructions

Chimney Support BraCket kit CSk-8Dm

If the exposed portion of chimney is greater than ve feet above roof

line, support wires are recommended to keep chimney secured.

Parts included with this kit:

PART # DESCRIPTION QTY

112117-01 Chimney Support Bracket 3

106216-01 Self-drilling Screw 6

16501 Poly bag 2 x 3 1

112130-01 Installation Instructions 1

901019-01 Cable Ferrule Connector 6

901020-01 Rope Cable Wire 50 ft

112356-01 Eye Bolt Screw 3

1. Attach chimney support brackets to outer pipe of chimney

with self-drilling screws provided in kit (screws must not

penetrate inner ue pipe).

2. Place chimney support brackets approximately 18" below

replace termination and space brackets approximately

120° apart.

3. Cut support wires to appropriate length for each leg of

support system. Insert end of support wire through cable

ferrule hole and loop into chimney support bracket then

back through other end of cable ferrule hole. Be sure to

allow enough return wire for cable ferrule.

4. Using standard pliers, crimp cable ferrules.

5. Screw eye bolt into roof. Apply waterproof sealant. Attach

other end of support wire into eye bolt screw through cable

ferrule (follow step #3). The angle of support wires should

not be more than 45° from horizontal when fastened to

roof.

Attachment of support wires to roof must be in accordance

with the manufactured home instructions or acceptable

construction standards.

10-FOOT RULE: The chimney ue gas outlet of the termination

must be a minimum distance of 3 feet above the highest point

where pipe penetrates roof, and must be a minimum distance

of 2 feet above the highest point of roof within a horizontal

distance of 10 feet.

DESA Heating, LLC

2701 Industrial Drive

P.O. Box 90004

Bowling Green, KY 42102-9004

www.desatech.com

1-866-672-6040

112130-01

Rev. C

09/07

120°

120° 120°

Top View of

Chimney

Support

Bracket

Chimney

Termination

18"

Self-Drilling

Screws

Angle of support

wire should not

be more than 45°

from horizontal.

Eye

Bolt

Screw

Chimney

Support

Bracket

Support

Wire

Cable

Ferrule

FMI CSK-8DM Operating instructions

FMI CSK-8DM Operating instructions

FMI CSK-8DM Operating instructions

Related papers

Other documents