ADJ Mega Go Bar 50 Battery Replacement Manual

Brand: ADJ

Model: Mega Go Bar 50

Type: Battery Replacement Manual

ADJ Mega Go Bar 50 is an impressive lighting fixture that offers vibrant and dynamic lighting effects to enhance any event or performance. Its versatility makes it suitable for a wide range of applications, from mobile DJ setups to stage productions.

With its powerful 50 built-in LEDs, the ADJ Mega Go Bar 50 produces rich colors and stunning patterns. The RGB color mixing system allows for a vast spectrum of color options, while the built-in programs and sound activation modes provide automated and dynamic lighting effects.

The fixture's compact size and lightweight design make it easy to transport and set up, while its rugged construction ensures durability. The ADJ Mega Go Bar 50 comes equipped with multiple control options, including DMX, sound activation, and a wireless remote, giving you flexibility in operation.

BATTERY REPLACEMENT

Start by removing both bracket end caps. Unscrew the four phillips screws that hold each end in

place.

The following instructions will help you replace your dead battery in the Mega Go Bar 50. To replace

the battery you need to carefully follow these instructions. If you have any questions please contact

American DJ customer support.

Customer Support: American DJ provides a customer support line, to provide set up help and to answer any

question should you encounter problems during your set up or initial operation. You may also visit us on the

web at www.American DJ.com for any comments or suggestions. Service Hours are Monday through Friday

8:00 a.m. to 4:30 p.m. Pacic Standard Time.

Voice: (800) 322-6337

Fax: (323) 582-2941

E-mail: support@AmericanDJ.com

Once the bracket end caps have

been removed, slide out the plastic

LED cover.

After you have removed the LED

cover. Look carefully at the LED strip.

You should see an area at one end

where the LED strip seperates. At that

end, slide the LED strip out, so that

small strip is removed from the hous-

ing. It is still connected to the other

strip, so do not try to fully remove it.

After this strip is out of the housing.

Slide the larger LED strip back the

opposite way.

Slide the strip until the full battery

housing is shown. This is as far as

you need to slide the LED strip. Slid-

ing it any farther could seperate wires

and cause damage.

Carefully disconnect the LED wire

harness from the PC board.

After disconnecting the wire harness,

“ip” the bar over so the rear is facing

up. Remove the two phillips screws

that secure the battery bracket.

After unscrewing and removing the

screws, “ip” the unit back over, and

carefully remove the battery bracket.

Disconnect the IR sensor cable from

the PC board.

Disconnect the DMX In connection

cable.

Disconnect the DMX Out connection

cable.

Disconnect the battery cable.

Carefully remove the battery.

After you have replaced the battery,

simply reassemble in reverse order.

Make sure that all cables are con-

nected correctly. When sliding the

LED strip back into place, do this

gently. You might feel some resis-

tance. DO NOT force the LED strip.

Slide the strip back in the opposite

direction, make sure that all cables

are out of the way. Please contact

American DJ customer service if you

need any help.

ADJ Mega Go Bar 50 Battery Replacement Manual

ADJ Mega Go Bar 50 Battery Replacement Manual

ADJ Mega Go Bar 50 Battery Replacement Manual

Related papers

Other documents