HOMESTOCK 99789 Operating instructions

Type
Operating instructions
Page 1 of 12
Office Cabinet
Product Dimensions:
18.90”L×13.78”D×45.67”H
Assembly Instructions
Please take a moment to read through the entire instruction booklet before assembly to
familiarize yourself with this product. Once you feel ready to start, follow the instructions
step by st ep and this should make this process as easy as we could make it for you.
Page 2 of 12
ADULT ASSEMBLY REQUIRED
CHOKING HAZARD
USE, MAINTENANCE & ASSEMBLY
PARENTAL SUPERVISION IS REQUIRED
WARNING CAUTION
SAFETY WARNINGS
This product includes small parts, sharp points and sharp edges in its unassembled state.
Keep unassembled parts away from children under 3 years of age, and animals.
Follow the information on the warnings appearing on table and on the
carton. Do not remove warning label from cabinet.
Do not allow children under 3 years of age to use the cabinet.
Do not use substitute parts. Contact the manufacturer or dealer for replacement parts.
Parents or Guardians should supervise use under the intended age specifically regarding
children that may have access to it and climb on the unit.
Do not allow horseplay on, under, or behind the unit and prohibit jumping on the cabinet.
If used improperly, your table may be pulled over or fall, creating risk of injury or
damage. Children should not be permitted to climb or pull on the cabinet.
Periodically check and ensure that the components are in their proper position, free from
damage, and that all connectors are tight.
Use on level surfaces only. Assemble on a soft level surface to avoid damage to unit or floor.
Do not use this item if any components are missing or damaged.
Do not use substitute parts. Contact the manufacturer or dealer for replacement parts.
Only clean using damp cloth and mild detergent, do not use bleach or abrasive cleaners.
Check you have all components and tools listed on page 4
Do not stand or put weight on this product during assembly, this could cause damage.
Remove all hardware from the plastic bags and separate them into groups.
Assemble the item as close to its final position (in the same room) as possible.
Certain assembly steps may be easier with 2 people.
Dispose of all packaging carefully and responsibly.
We do not recommend power screwdrivers. Only use hand screwdrivers to prevent
damage to unit.
Enfants morts suite au basculement d’un meuble.
Afin de limiter le risque de basculement de meuble:
TOUJOURS utiliser les fixations anti-basculement.
NE JAMAIS installer de TV sur ce produit.
NE JAMAIS laisser d’enfants se tenir debout sur les tiroirs,
portes ou etageres, y grimper ou s’y suspendre.
NE JAMAIS ouvrir plus d’un tiroir a la fois.
TOUJOURS placer les choses les plus lourdes dans les tiroirs du bas.
Han muerto ninos por el vuelco de meubles.
Para limitar el riesgo de vuelco de los meubles:
Utilisar SIEMPRE las fijaciones antivuelco que suministran.
NUNCA instalar un TV sobre este producto.
NUNCA permitar que los ninos se pongan de pie, trepen o
se cuelguen de los cajones, puertas o baldas.
NUNCA abrir mas de un cajon a la vez.
Colocar los objetos mas pesados en los cajones inferiores.
!
FURNITURE TIP-OVER HAZARD
Children have died from furniture tip-over
To reduce the risk of furniture tip-over:
ALWAYS install tip-over restraint especially if used by a wall or in the open.
NEVER put a TV on this product
NEVER allow children to stand, climb or hang on drawers, doors, or shelves.
NEVER open more than one drawer at a time.
ALWAYS place heaviest items in lowest cabinet.
Keep these instructions for future reference.
Page 3 of 12
This drawing is to give you an overall idea only of how this assembly will go together
and does not replace the assembly instructions.
Please take a moment to read through the whole instruction booklet before assembly to familiarize
yourself with this product. Once you feel ready to start, follow the instructions step by step and this should
make this process as easy as we could make it for you.
ASSEMBLY AT A GLANCE
1
2
3
4
7
9
10
11
12
14
15
16
13
5
6
8
COMPONENT PARTS
Please check that you have all the parts listed below
ASSEMBLY HARDWARE
ABC
Screw ×112
Drawer Slide
×9 Back Buckle×12
D
Cam Bolt
×28
E
Wood Dowel
Pin
×32
F
×28 Cam Lock
G
Screw
×42 Plastic Expansion Nail× 2 Wall Decal× 2
HI
Page 4 of 12
Tools Required Tools Required
Phillips Screwdriver
(Medium) (not included)
*Do Not Use Power
Screwdriver or Drill.
Hex Screwdriver
(included)
1. Top Panel ×1
2. Left Side Panel×1
3. Right Side Panel×1
4. Bottom Panel×1
5. First Back Side Panel ×1
6. Second Back Side Panel ×1
7. Third Back Side Panel×1
8. Fourth Back Side Panel ×1
9. Fifth Back Side Panel ×1
10. Drawer Back ×9
11. Drawer Left ×9
12. Drawer Right ×9
13. Drawer Bottom ×9
14. Drawer Front ×5
15. Drawer Front ×4
16. Support Side Panel ×1
1
2
3
4
7
9
10
11
12
14
15
16
13
5
6
8
LD RD CRCL
J
Screw ×12
G
G
A
A
A
23
10
11
12
G
G
ASSEMBLY INSTRUCTIONS
2
1
Select A×54 and 2×1,
3×1. Position 2 in the left,
position 3 in the right. Insert
A×9 into the one side of the
B CL, other A×9 into the
middle of the B CL, other A×9
into the other side of the B
CL.Insert B CL×9 into the
2.Repeat the steps for B CR
and the 3.
Select 10×9,11×9,12×9, and
G×36. Insert G×2 into the
hole of the 11 into the 10.Re-
peat the steps for 10 and 12.
Repeat the steps for another
Drawer panels×8.
Page 5 of 12
B
B
B
B
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
AA
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
B
B
B
B
BB
B
B
B
B
B
B
B
B
B
CL
AA
B
CR
Page 6 of 12
ASSEMBLY INSTRUCTIONS
4
3
Select 13×9 ,14×5 , D×10,
E×10, F×10. Install the 13
along the grooves on the
both sides of the 11 and 12.
Install the 14 on the 11 with
the D, E and F. Repeat the
steps for the 14 and the 12.
Repeat for another Draw-
er×4.
Select A × 30, B DR×5, B DL ×
5. Put the Drawer upside
down. Insert A×3 into the B
DR into the 12 tightly.
Repeat the steps for B DL and
the 11.Repeat the steps for
another Drawer ×4.
10
14
13
11
12
D
D
F
F
E
E
14
13
12
A
A
A
B
B
A
A
A
11
DR
DL
Select A × 24, C DR×4, C DL
×4. Put the Drawer upside
down. Insert A×3 into the C
DR into the 12 tightly.
Repeat the steps for C DL and
the 11.Repeat the steps for
another Drawer ×3.
10
15
13
11
12
D
D
F
F
E
E
15
13
12
A
A
A
C
C
A
A
A
11
DR
DL
Page 7 of 12
ASSEMBLY INSTRUCTIONS
6
5
Select 15×4,D×8,E×8,F×8.
Install the 15 on the 11 with
the D, E and F. Repeat the
steps for the 15 and the 12.
Repeat for another Draw-
er×3.
3
3
2
7
Page 8 of 12
ASSEMBLY INSTRUCTIONS
8
7
Select 3,6,8,16, D×3,E×3,F×3.
Insert the 6 into the 3 with
the D,E,F tightly.Repeat for
the 8 and the 16.
Select
2,3,6,7,8,16,D×3,E×3,F×3.
Install the 7 along the
grooves of the 6 and the 8.
Insert the 2 into the 6 and
the 8 with the D×2, E×2, F×2.
Repeat for the 2 and the 16.
6
16
8
D
D
D
D
D
D
E
F
F
F
E
E
6
8
16
E
F
F
F
E
E
2
2
1
4
3
3
G
G
G
9
8
E
E
6
F
F
D
D
D
D
E
E
Page 9 of 12
ASSEMBLY INSTRUCTIONS
10
9
Select 9,4, E×4,G×4.
Install the 9 along the groove
of the 8. Insert one side of
the 4 into the 2 with
E×2,G×2.Repeat for the other
side of the 4 and the 3.
Select 1,5,D×4,E×4,F×4.
Install the 5 along the groove
of the 6.Insert one side of the
1 into the 2 with the
D×2,E×2,F×2. Repeat for the
1 and the 3.
G
5
F
F
2
ASSEMBLY INSTRUCTIONS
11
Select C ×12, J×12.
Install the C ×12 into the two
sides of the back of the Cabi-
net with the J ×12.
Put the Drawers ×9 into the
Cabinet.
Page 10 of 12
14
14
14
14
14
15
15
15
15
12
C
C
C
C
C
C
C
C
C
C
C
C
J
J
J
J
J
J
J
J
J
J
J
J
ASSEMBLY INSTRUCTIONS
Select I × 2, A×4.
Install the I ×2 into the two
sides of the back of the Cabi-
net with the A ×4.
Select H × 2, G×2.
Install the H ×2 into the wall
with the G ×2.
H
G
G
G
H
H
A
A
I
I
A
AA
I
13
14
Page 11 of 12
Page 12 of 12
ASSEMBLY COMPLETE
A A YCONGR TUL TIONS, OUR OFFICE
CABINET IS COMPLETE!
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

HOMESTOCK 99789 Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages