Xing Da Electronics XO-10028 User guide

Brand: Xing Da Electronics

Model: XO-10028

Type: User guide

Xing Da Electronics XO-10028 is a wireless Bluetooth 5.1 earbuds with a built-in microphone and a charging case. The earbuds have a battery capacity of 40 mAh and can last up to 1.5 hours of playtime on a single charge. The charging case has a battery capacity of 400 mAh and can charge the earbuds up to 5 times. The earbuds have a number of features, including:

Transparency Mode: This mode allows you to hear your surroundings while listening to music.
ANC ON/OFF: This mode allows you to turn on or off the active noise cancellation.
Voice Assistant/Siri: You can activate your voice assistant or Siri by triple-touching the earbud button.

Transparency Mode: This mode allows you to hear your surroundings while listening to music.
ANC ON/OFF: This mode allows you to turn on or off the active noise cancellation.
Voice Assistant/Siri: You can activate your voice assistant or Siri by triple-touching the earbud button.

FCC ID：2ADK3XO-10028

Loo

Charging :

1. Included with your device is a Micro USB cable. Insert the Micro USB end into the Micro USB Port on the bottom of the

charging case.

2. Insert the charging cable’s USB plug into the USB port of a computer or suitable USB charging adapter.

3.Case charge the earbuds: Solid Red LED on earbuds when charging, LEDs on both earbuds turn off when earbuds are fully

charged.

4.Charge the case: Red LED flash when charging and LED turn off when case fully charged.

Bluetooth pairing:

Remove earbuds from case, prompt a voice "Power on", then a beep to indicate both earbuds sync to each other, now main

earbud LED flash Red& Blue, secondary earbud flash Blue slowly.

After connect Bluetooth, prompt a voice "connected", now both earbuds LEDs flash blue slowly.

Touch and hold the button 1 second to enter "Transparency Mode',touch and hold the button 1 second again to enter "ANC

ON",touch and hold the button 1 second again to enter "ANC OFF",

disconnect Bluetooth will prompt a voice "Disconnected". Long press earbuds button about 5 seconds to power off earbuds and

hear a voice prompt "Power off".

If disconnect Bluetooth after 5 mins, the earbuds will auto shut off.

Earphones control:

1.A single touch of the Right or Left button to Play/Pause/Answer/Refuse/End a Call.

2.Double-touch the right multifunction button to go to the next track and double-touch the left button to go to

the previous track.

Triple touch earbud button , you will hear a beeping sound to indicate that your voice Assistant/Siri is “activated” and awaiting

your commands.

3.Put one earbud into case, the other will stay on. Put both earbuds into case, earbuds will turn off.

Note:

1. Keep the product dry; do not place the product in damp places.

2. Keep out of direct sunlight and high temperatures High temperatures may result in damage.

3. Keep out of cold temperatures, this will help avoid internal damage.

4. Do not disassemble the product.

5. Avoid dropping the product.

6. Do not continue to charge the product over 10 hours.

7. When charging use the Micro USB charging cord that came with the product.

SPECIFICATIONS:

BT version : 5.1

Charging time :1.5 hour(earabuds),2.5 hours (charging box)

Battery capacity Earbuds : 40 mAh

Battery capacity Charging box 400 mAh

Input of the charging box:5V/350mA

FCC

Statement

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modiﬁcations to this device not explicitly

approved by manufacturer could void your authority to operate this

equipment.

This device complies with part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

RF Exposure Information

The device has been evaluated to meet general RF exposure

requirement. The device can be used in portable exposure

condition without restriction.

Xing Da Electronics XO-10028 User guide

Brand: Xing Da Electronics

Model: XO-10028

Type: User guide

Transparency Mode: This mode allows you to hear your surroundings while listening to music.
ANC ON/OFF: This mode allows you to turn on or off the active noise cancellation.
Voice Assistant/Siri: You can activate your voice assistant or Siri by triple-touching the earbud button.

Download PDF

report

Xing Da Electronics XO-10028 User guide

Xing Da Electronics XO-10028 User guide

Other documents