Philips CED320 User manual

CED320
Philips
Brand
Philips
Model
CED320
Category
Car media receivers
Type
User manual

This manual is also suitable for

Register your product and get support at
CED320
ENG Quick Start Guide
3
183 mm
53.5mm
5mm
1
Antenna (Black)
Subwoofer (Blue)
Parking (Green/White)
Camera (Pink)
Rear line out R (Red)
Front line out R (Red)
Rear line out L (White)
Front line out L (White)
Camera in (Yellow)
Video out 2 (Yellow)
Video out 1 (Yellow)
2
English
Connect wires: ISO connectors
Caution
Ensure that all loose leads are insulated with
•
electrical tape.
1
Pull out the ISO connectors from the car
dashboard and connect them to the bigger
end of the supplied standard connector.
2
Connect the other end of supplied standard
connector to the unit.
3
Do the other connections, if applicable.
Attach the front panel
1
Attach the trim plate.
2
Insert the left side of the panel in the chassis
until it is correctly engaged.
3
Press the right side of the panel until the
mechanism locks it into place.
4
Close the front panel.
Mount in the dashboard
Note
For proper operation of the DVD player, the •
chassis must be mounted within 20 degree
horizontal. Ensure that the unit is mounted
within this limitation.
1
If the car does not have an on-board drive or
navigation computer, disconnect the negative
terminal of the car attery.
If you disconnect the car battery in •
a car that has an on-board drive or
navigation computer, the computer may
lost its memory.
If the car battery is not disconnected, •
to avoid short-circuit, ensure that bare
wires do not touch each other.
2
Ensure that car dashboard opening is within
these measurements:
3
Remove the two transport screws on the
top of the unit.
4
Remove the mounting sleeve with the re-
moval keys.
5
Install the sleeve into the dashboard and
bend the tabs outward to fi x the sleeve.
If the unit is not fi xed by sleeve but by •
the supplied screws, skip this step.
6
Place the rubber cushion over the end of the
bolt.
7
Slide the unit into the dashboard until a click
sound is heard.
8
Reconnect the negative terminal of the car
battery.
Detach the front panel
The front panel can be detached and taken with
you to deter theft.
Note
Before installing the unit, detach the front •
panel.
1
Press
to release the panel.
2
Open the panel, then push the right side
panel toward the left side to disengage it
from the chassis.
3
Take off the panel and store it in the supplied
carry case to protect it from dirt or damage.
Turn on
1
Press the knob to turn on the unit.
The unit plays the last listened program:
»
DVD, Tuner, USB or SD/MMC Card (if there is
USB device or SD/MMC card connected).
To turn off the unit, press the •
knob for
more than 2 seconds.
When the unit is idle for over 5 minutes, it •
goes to standby mode and displays screen
saver.
Set clock
1 Press MENU.
2 Press the navigation buttons to select [SET-
TINGS], then press SEL on the remote
control.
3 Select [SYSTEM], then press .
4 Select [TIME MODE], then press .
The time mode options are displayed:
»
»
[12 HOUR MODE]
»
[24 HOUR MODE]
5 Sselect a mode, then press SEL.
6 Press to return to previous menu and
select [TIME ADJUST], then press
.
7 Press or to enter clock, then press SEL.
Tune to a radio station
1 Press SOURCE to select Tuner.
2 Press or to select band.
»
[FM] or [AM] is displayed.
3 Press or to tune to a radio station
manually.
To search for radio station automatically, •
press
or for 3 seconds.
Play discs
1 Press to open the front panel.
2 Insert the disc into the disc slot with label
side facing up.
Play resumes from the point where it was
»
last stopped.
3 To remove the disc, press the button.
When the disc is ejected, the unit switches
»
to TUNER mode automatically.
4 Close the front panel.
After a few seconds, the screen turns on.
»
For video discs, if a menu appears: press
»
or
to select an item, then press to start
play.
For discs that contain MP3s, WMAs, or
»
JPEGs: , press
or to select a folder/track/
picture, then press
to start play.
Insert USB device
1 Slide down the USB socket cover.
2 Insert the USB device into the USB socket.
The unit starts playing from the USB
»
device automatically.
Insert SD/MMC card
1 Press to open the front panel.
2 Insert the SD or MMC card into the card
slot.
The unit starts playing from the SD/MMC
»
card automatically.
© 2008 Koninklijke Philips Electronics N.V.
All rights reserved.
4
5
6
  • Page 1 1
  • Page 2 2

Philips CED320 User manual

CED320
Philips
Brand
Philips
Model
CED320
Category
Car media receivers
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents