6 For more information, visit global.irobot.com
EN
Cleaning
Use your robot frequently to maintain well-conditioned floors.
• Your robot will automatically explore and clean your home, moving in a
methodical manner across the floor, with some overlap from one pass to
the next to ensure that every spot on the floor is cleaned three times. If you
are looking for a quicker clean or a deeper clean than this default setting,
or if you want to adjust the amount of water sprayed, you can change your
cleaning preferences from the iRobot Home App.
• Your robot will return to the charging station at the end of a cleaning job,
whenever it needs to recharge or when the tank needs to be refilled.
Note: If the ‘CLEAN’ text is pulsing while charging, your robot is in the
middle of a cleaning job and will automatically resume where it left off
once recharged.
• To send the robot back to its charging station, tap (home). A blue light ring
pattern will indicate that the robot is seeking the charging station. This feature
will only work if your robot started the job from the charging station.
• When the robot senses that its tank needs to be filled, the light ring indicator
will illuminate in a red sweeping motion towards the lid latch.
• Clean smaller designated areas (3.3 ft2/1 m2) by placing your robot at the
bottom centre of the space you’d like to focus on. Tap (spot clean) to
start cleaning.
Tips for Optimising Performance
• Your robot works best when used with the iRobot Home app.
• For optimal mopping performance, we recommend that you vacuum first to
pick up large dirt and debris before running Braava jet®.
• Your robot will only run with Braava jet® m Series pads, which are made
specifically for Braava jet® m Series robots.
• Use a new pad for each cleaning job, and do not pre-wet the pads prior to use.
• Keep your charging station plugged in and the area around it clear of clutter.
• You can use a Dual Mode Virtual Wall® Barrier to help keep your robot in
places that you want to be cleaned, and out of the ones you don’t. (Sold
separately)
• Within the iRobot Home App, you can adjust cleaning preferences to modify
cleaning power, speed and coverage.
Just Press CLEAN
Tap to Start/Pause/Resume
Hold for 3 seconds to end a job
and put the robot to sleep
Hold for 10 seconds to reboot
Using Your Braava jet® m6 Robot Mop