Kohler K-9497-CP Installation guide

Hello! I've reviewed the service kit instructions for the Trim Ring K-9497. This document provides a step-by-step guide on how to replace the trim ring, and verify the keypad's proper functionality, including information about the light sequence indicator and automatic data download. I'm ready to answer your questions!
How to remove the old trim ring?

How to install the new trim ring?

What happens after restoring power to the whirlpool?

1021753-9-A

SERVICE KIT INSTRUCTIONS

Trim Ring

Replacement

K-9497

Trim Ring

Keypad

Replace Trim Ring

-Turn power to the whirlpool off.

-Inspect new trim ring for damage.

-Remove the old trim ring by turning it counterclockwise.

-Thread new trim ring onto the keypad. The top of the keypad should

be flush with the top of the trim ring.

Verify Keypad Function

-Restore power to the whirlpool.

-The keypad will automatically download information to the whirlpool

control. This process takes approximately five seconds. A light

sequence will illuminate up and down the indicator bar until the

process is complete.

-Press the power button and verify that all modes work properly. Refer

to the Homeowners Guide shipped with your whirlpool.

-If a remote control is used, refer to the Homeowners Guide for

programming instructions.

1021753-9-A2Kohler Co.

E2003 Kohler Co.

1021753-9-A

USA: 1-800-4-KOHLER

Canada: 1-800-964-5590

Mexico: 001-877-680-1310

kohler.com