2. GW Instek
  3. Usage a terminal programmer to control GPM-8212

GW Instek Usage a terminal programmer to control GPM-8212 User manual

  • Hello! I've reviewed the user guide for the GPM-8212 Power Meter and understand how to set it up using Real-Term software. The document covers important configuration steps, such as setting the baud rate and configuring the message terminator. It also explains how to send commands using the 'Send ASCII' function. I'm ready to answer questions you might have about the usage of GPM-8212 based on this documentation.
  • What is the default baud rate for GPM-8212?
    What is the required message terminator setting?
    What should user press after completing settings?
How to get GPM-8212 ONLINE by using the Real-Term
GPM-8212 configuration:
Checking the GPM-8212 Baud Rate
(Operation by Key-pad)
Real-term Configuration:
Display configuration
Ascii
Port configuration
Baud : 9600
Port : depend on current setting
Parity : None
Bata Bits : 8 bits
Stop Bits : 1 bit
Hardware Flow Control : None
[NOTE]
After complete the above setting, please
press “Change” to confirm.
Send (message terminator) configuration
EOL : CRLF
Press “Send ASCII” to
send out command.
Command
/